RuPAC2014 - List of Keywords (electronics)

Paper	Title	Other Keywords	Page
THPSC23	Upgrade of BPM System at VEPP-4M Collider	positron, electron, controls, operation	368
	E.A. Bekhtenev NSU, Novosibirsk, Russia E.A. Bekhtenev, G.V. Karpov BINP SB RAS, Novosibirsk, Russia
	Funding: Ministry of Education and Science of the Russian Federation Developed in BINP wideband beam position monitor (BPM) electronics has been installed at the VEPP-4M electron-positron collider. The VEPP-4M operates with two electron and two positron bunches. Wide bandwidth of new electronics (200 MHz) allows the separate measurements of electron and positron bunches with time interval between bunches up to 18 ns. 18 BPMs located near four meeting points are supplied with new electronics. The electronics can measure the position of each of four bunches. BPM system works at two modes: slow closed orbit measurements and turn-by-turn measurements. We present details of system design and operation.

THPSC43	Electrostatic Pick-ups for Debunched Beams at INR Linac	pick-up, simulation, operation, detector	420
	S.A. Gavrilov, P.I. Reinhardt-Nickoulin, I.V. Vasilyev RAS/INR, Moscow, Russia
	Pick-ups are one of the most widespread non-destructive diagnostics at charged particle accelerators. These detectors, also known as beam position monitors, are generally used for the center-of-mass position measurements of bunched beams. The paper describes the research results for infrequent case of debunched beams operation. Measurement peculiarities and distinctive features of electronics are presented. The results of test bench-based measurements and 3D finite element simulations are discussed.
	Poster THPSC43 [2.287 MB]

Paper

Title

Other Keywords

Page

THPSC23

Upgrade of BPM System at VEPP-4M Collider

positron, electron, controls, operation

368

E.A. Bekhtenev
NSU, Novosibirsk, Russia
E.A. Bekhtenev, G.V. Karpov
BINP SB RAS, Novosibirsk, Russia

Funding: Ministry of Education and Science of the Russian Federation
Developed in BINP wideband beam position monitor (BPM) electronics has been installed at the VEPP-4M electron-positron collider. The VEPP-4M operates with two electron and two positron bunches. Wide bandwidth of new electronics (200 MHz) allows the separate measurements of electron and positron bunches with time interval between bunches up to 18 ns. 18 BPMs located near four meeting points are supplied with new electronics. The electronics can measure the position of each of four bunches. BPM system works at two modes: slow closed orbit measurements and turn-by-turn measurements. We present details of system design and operation.

THPSC43

Electrostatic Pick-ups for Debunched Beams at INR Linac

pick-up, simulation, operation, detector

420

S.A. Gavrilov, P.I. Reinhardt-Nickoulin, I.V. Vasilyev
RAS/INR, Moscow, Russia

Pick-ups are one of the most widespread non-destructive diagnostics at charged particle accelerators. These detectors, also known as beam position monitors, are generally used for the center-of-mass position measurements of bunched beams. The paper describes the research results for infrequent case of debunched beams operation. Measurement peculiarities and distinctive features of electronics are presented. The results of test bench-based measurements and 3D finite element simulations are discussed.

Poster THPSC43 [2.287 MB]