| Paper | Title | Page |
|---|---|---|
| MOPA007 | Polarized Proton Collisions at RHIC | 600 |
|
||
|
Funding: The work was performed under the auspices of the U.S. Department of Energy and RIKEN Japan. The Relativistic Heavy Ion Collider~(RHIC) provides not only collisions of ions but also collisions of polarized protons. In a circular accelerator, the polarization of polarized proton beam can be partially or fully lost when a spin depolarizing resonance is encountered. To preserve the beam polarization during acceleration, two full Siberian snakes were employed in RHIC to avoid depolarizing resonances. In 2003, polarized proton beams were accelerated to 100~GeV and collided in RHIC. Beams were brought into collisions with longitudinal polarization at the experiments STAR and PHENIX by using spin rotators. RHIC polarized proton run experience demonstrates that optimizing polarization transmission efficiency and improving luminosity performance are significant challenges. Currently, the luminosity lifetime in RHIC is limited by the beam-beam effect. The current state of RHIC polarized proton program, including its dedicated physics run in 2005 and efforts to optimize luminosity production in beam-beam limited conditions are reported. |
||
| MOPC003 | Benchmarking of Simulation Codes Based on the Montague Resonance in the CERN Proton Synchrotron | 330 |
|
||
| Experimental data on emittance exchange by the space charge driven ‘‘Montague resonance'' have been obtained at the CERN Proton Synchrotron in 2002-04 as a function of the working point. These data are used to advance the benchmarking of major simulation codes (ACCSIM, IMPACT, MICROMAP, ORBIT, SIMBAD, SIMPSONS, SYNERGIA) currently employed world-wide in the design or performance improvement of high intensity circular accelerators. In this paper we summarize the experimental findings and compare them with the first three steps of simulation results of the still progressing work. | ||
| MPPT046 | Superconducting Helical Snake Magnet for the AGS | 2935 |
|
||
|
Funding: DOE A superconducting helical magnet has been built for polarized proton acceleration in the Brookhaven AGS. This "partial Snake" magnet will help to reduce the loss of polarization of the beam due to machine resonances. It is a 3 T magnet some 1940 mm in magnetic length in which the dipole field rotates with a pitch of 0.2053 degrees/mm for 1154 mm in the center and a pitch of 0.3920 degrees/mm for 393 mm in each end. The coil cross-section is made of two slotted cylinders containing superconductor. In order to minimize residual offsets and deflections of the beam on its orbit through the Snake, a careful balancing of the coil parameters was necessary. In addition to the main helical coils, a solenoid winding was built on the cold bore tube inside the main coils to compensate for the axial component of the field that is experienced by the beam when it is off-axis in this helical magnet. Also, two dipole corrector magnets were placed on the same tube with the solenoid. A low heat leak cryostat was built so that the magnet can operate in the AGS cooled by several cryocoolers. The design, construction and performance of this unique magnet will be summarized. |
||
| FPAE006 | Optimization of AGS Polarized Proton Operation with the Warm Helical Snake | 1003 |
|
||
|
Funding: US DOE and RIKEN Japan. A normal conducting helical dipole partial Siberian snake (Warm Snake) has been installed in the Alternating Gradient Synchrotron (AGS) at Brookhaven National Laboratory (BNL) for overcoming all of imperfection depolarizing resonances and reducing the transverse coupling resonances caused by the solenoidal Siberian snake which had been operated in AGS before the last polarized run. The polarized proton beam has been accelerated successfully with the warm snake and the polarization at extraction of the AGS was increased to 50% as opposed to 40% with the solenoidal snake. The magnetic field and beam trajectory in the warm snake was calculated by using the OPERA-3D/TOSCA software. We present optimization of the warm snake with beam during RUN5. |
||
| FPAT003 | Joining the RHIC Online and Offline Models | 880 |
|
||
|
Funding: Work performed under the auspices of the U.S. Department of Energy. The paper presents an interface encompassing the RHIC online ramp model and the UAL offline simulation framework. The resulting consolidated facility aims to minimize the gap between design and operational data, and to facilitate analysis of RHIC performance and future upgrades in an operational context. The interface is based on the Accelerator Description Exchange Format (ADXF), and represents a snapshot of the RHIC online model which is in turn driven by machine setpoints. This approach is also considered as an intermediate step towards integrating the AGS and RHIC modeling environments to produce a unified online and offline AGS model for operations. |
||
| FPAE014 | Acceleration of Polarized Protons in the AGS with Two Helical Partial Snakes | 1404 |
|
||
|
Funding: Work supported by U.S. DOE and RIKEN of Japan. The RHIC spin program requires 2*1011 proton/bunch with 70% polarization. As the injector to RHIC, AGS is the bottleneck for preserving polarization: there is not enough space in the ring to install a full snake to overcome the numerous depolarizing resonances. An ac dipole and a partial Siberian snake have been used to preserve beam polarization in the past. The correction with this scheme is not 100% since not all depolarizing resonances can be overcome. Recently, two helical snakes with double pitch design have been built and installed in the AGS. With careful setup of optics at injection and along the ramp, this combination can eliminate all depolarizing resonances encountered during acceleration. This paper presents the accelerator setup and preliminary results. |