SRF2017 - List of Authors (Xiao, L.)

Paper	Title	Page
MOPB036	The Study of Deposition Method of Nb3Sn Film on Cu Substrate	131
	L. Xiao, X.Y. Lu, W.W. Tan, D. Xie, D.Y. Yang, Y. Yang, Z.Q. Yang, J. Zhao PKU, Beijing, People's Republic of China
	Our work is mainly focused on the fabrication methods of Nb3Sn films on Cu substrates and film's properties. There are diffraction peaks of Nb3Sn in the X-ray diffraction patterns in which without diffraction peaks of copper compounds. Scanning electron microstructures of Nb3Sn film reflect its nice compactness and binding force between film and substrate.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-SRF2017-MOPB036
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPB080	The Stable Operation of MPG and Measurement of Output	254
	B.T. Li, X.Y. Lu, L. Xiao, D.Y. Yang, Y. Yang, Z.Q. Yang, J. Zhao PKU, Beijing, People's Republic of China
	The concept of micro-pulse electron gun(MPG) was proposed decades ago. It can provide electron beam with high current, short pulse and low emittance. But it is still not put into practical use as electron source because of its unsteady operating state. This paper presents an experimental result of the steady running of MPG which can operate stably for more than ten hours. The energy spread of the electron beam is also measured, the peak is located at near 20eV and half width is less than 15eV .
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-SRF2017-MOPB080
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPB055	Nb3Sn Thin Film Deposition On Copper By DC Magnetron Sputtering	512
	W.W. Tan, B.T. Li, X.Y. Lu, L. Xiao, D. Xie, D.Y. Yang, Y. Yang, Z.Q. Yang, J. Zhao PKU, Beijing, People's Republic of China
	Nb3Sn for SRF cavities has been coated on copper samples by DC magnetron Sputtering. Pure Nb target and pure Sn target were installed separately in the magnetron sputtering device. Nb3Sn precursor was coated on copper in the Ar atmosphere of 0.5 Pa. The Nb3Sn precursor was annealed in the vacuum furnace whose pressure is 10^-4 Pa. The XRD results demonstrate the exist of Nb3Sn crystal, and MPMS results show superconductivity of Nb3Sn. The highest critical temperature obtained is 15K.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-SRF2017-TUPB055
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

The Study of Deposition Method of Nb3Sn Film on Cu Substrate

131

L. Xiao, X.Y. Lu, W.W. Tan, D. Xie, D.Y. Yang, Y. Yang, Z.Q. Yang, J. Zhao
PKU, Beijing, People's Republic of China

Our work is mainly focused on the fabrication methods of Nb3Sn films on Cu substrates and film's properties. There are diffraction peaks of Nb3Sn in the X-ray diffraction patterns in which without diffraction peaks of copper compounds. Scanning electron microstructures of Nb3Sn film reflect its nice compactness and binding force between film and substrate.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-SRF2017-MOPB036

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPB080

The Stable Operation of MPG and Measurement of Output

254

B.T. Li, X.Y. Lu, L. Xiao, D.Y. Yang, Y. Yang, Z.Q. Yang, J. Zhao
PKU, Beijing, People's Republic of China

The concept of micro-pulse electron gun(MPG) was proposed decades ago. It can provide electron beam with high current, short pulse and low emittance. But it is still not put into practical use as electron source because of its unsteady operating state. This paper presents an experimental result of the steady running of MPG which can operate stably for more than ten hours. The energy spread of the electron beam is also measured, the peak is located at near 20eV and half width is less than 15eV .

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-SRF2017-MOPB080

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPB055

Nb3Sn Thin Film Deposition On Copper By DC Magnetron Sputtering

512

W.W. Tan, B.T. Li, X.Y. Lu, L. Xiao, D. Xie, D.Y. Yang, Y. Yang, Z.Q. Yang, J. Zhao
PKU, Beijing, People's Republic of China

Nb3Sn for SRF cavities has been coated on copper samples by DC magnetron Sputtering. Pure Nb target and pure Sn target were installed separately in the magnetron sputtering device. Nb3Sn precursor was coated on copper in the Ar atmosphere of 0.5 Pa. The Nb3Sn precursor was annealed in the vacuum furnace whose pressure is 10^-4 Pa. The XRD results demonstrate the exist of Nb3Sn crystal, and MPMS results show superconductivity of Nb3Sn. The highest critical temperature obtained is 15K.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-SRF2017-TUPB055

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)