IBIC2016 - List of Authors (Griesmayer, E.)

Paper	Title	Page
MOPG14	The Use of Single-crystal CVD Diamond as a Position Sensitive X-ray Detector	71
	E. Griesmayer, P. Kavrigin, Ch. Weiss CIVIDEC Instrumentation, Wien, Austria C. Bloomer DLS, Oxfordshire, United Kingdom
	Synchrotron light sources generate intense beams of X-ray light for beamline experiments, and the stability of these X-ray beams has a large impact on the quality of the experiments that can be performed. User experiments increasingly utilise micro-focus techniques, focusing the X-ray beam size to below 10 microns at the sample point, with beamline detectors operating at kHz bandwidths. Thus, there is a demand for non-invasive diagnostic techniques that can reliably monitor the X-ray beam position with sub-micron accuracy in order to characterise X-ray beam motion, at corresponding kHz bandwidths. Reported in this paper are measurements from single-crystal CVD diamond detectors, and a comparison with the previous-generation of polycrystalline CVD diamond detectors is offered. Single-crystal diamond is shown to offer superior uniformity of response to incident X-rays, and excellent intensity and position sensitivity. Measurements from single-crystal diamond detectors installed at Diamond Light Source are presented, and their use in feedback routines in order to stabilise the X-ray beam at the sample point is discussed.
DOI •	reference for this paper ※ DOI:10.18429/JACoW-IBIC2016-MOPG14
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPG19	Diamond Monitor Based Beam Loss Measurements in the LHC	82
	C. Xu, B. Dehning, F.S. Domingues Sousa CERN, Geneva, Switzerland E. Griesmayer CIVIDEC Instrumentation, Wien, Austria
	Two pCVD diamond based beam loss monitors (dBLM) are installed near the primary collimators of the LHC, with a dedicated, commercial readout-system used to acquire their signals. The system is simultaneously able to produce a high sampling rate waveform and provide a real-time beam loss histogram for all bunches in the machine. This paper presents the data measured by the dBLM system during LHC beam operation in 2016.
DOI •	reference for this paper ※ DOI:10.18429/JACoW-IBIC2016-MOPG19
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

The Use of Single-crystal CVD Diamond as a Position Sensitive X-ray Detector

71

E. Griesmayer, P. Kavrigin, Ch. Weiss
CIVIDEC Instrumentation, Wien, Austria
C. Bloomer
DLS, Oxfordshire, United Kingdom

Synchrotron light sources generate intense beams of X-ray light for beamline experiments, and the stability of these X-ray beams has a large impact on the quality of the experiments that can be performed. User experiments increasingly utilise micro-focus techniques, focusing the X-ray beam size to below 10 microns at the sample point, with beamline detectors operating at kHz bandwidths. Thus, there is a demand for non-invasive diagnostic techniques that can reliably monitor the X-ray beam position with sub-micron accuracy in order to characterise X-ray beam motion, at corresponding kHz bandwidths. Reported in this paper are measurements from single-crystal CVD diamond detectors, and a comparison with the previous-generation of polycrystalline CVD diamond detectors is offered. Single-crystal diamond is shown to offer superior uniformity of response to incident X-rays, and excellent intensity and position sensitivity. Measurements from single-crystal diamond detectors installed at Diamond Light Source are presented, and their use in feedback routines in order to stabilise the X-ray beam at the sample point is discussed.

DOI •

reference for this paper ※ DOI:10.18429/JACoW-IBIC2016-MOPG14

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPG19

Diamond Monitor Based Beam Loss Measurements in the LHC

82

C. Xu, B. Dehning, F.S. Domingues Sousa
CERN, Geneva, Switzerland
E. Griesmayer
CIVIDEC Instrumentation, Wien, Austria

Two pCVD diamond based beam loss monitors (dBLM) are installed near the primary collimators of the LHC, with a dedicated, commercial readout-system used to acquire their signals. The system is simultaneously able to produce a high sampling rate waveform and provide a real-time beam loss histogram for all bunches in the machine. This paper presents the data measured by the dBLM system during LHC beam operation in 2016.

DOI •

reference for this paper ※ DOI:10.18429/JACoW-IBIC2016-MOPG19

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)