2011 Particle Accelerator Conference - List of Authors (Tian, Y.)

Paper

Title

Page

BPM Inputs to Physics Applications at NSLS-II

465

Y. Hu, L.R. Dalesio, J.H. DeLong, K. Ha, J. Mead, I. Pinayev, G. Shen, O. Singh, Y. Tian, K. Vetter, L.-H. Yu
BNL, Upton, Long Island, New York, USA

A new BPM (Beam Position Monitor) electronics is under development and in good progress at NSLS-II. This in-house BPM receiver with many new features is comparable to commercial solution. BPM data for fast orbit feedback (FOFB) is one of the most important physics applications. The procedure to use BPM for FOFB is introduced firstly. Then, different BPM data flows associated with different physics requirements and applications are discussed. And control implementation of BPM system for physics applications is presented.

MOP211

NSLS-II RF Beam Position Monitor

495

K. Vetter, J.H. DeLong, A.J. Della Penna, K.M. Ha, Y. Hu, B.N. Kosciuk, J. Mead, I. Pinayev, O. Singh, Y. Tian
BNL, Upton, Long Island, New York, USA
G.J. Portmann
LBNL, Berkeley, California, USA
J.J. Sebek
SLAC, Menlo Park, California, USA

Funding: Work supported by the U.S. DOE under contract No. DE-AC02-98CH10886.
An internal R&D program has been undertaken at BNL to develop a sub-micron RF Beam Position Monitor (BPM) for the NSLS-II 3rd generation light source that is currently under construction. The BPM R&D program started in August 2009. Successful beam tests were conducted 15 months from the start of the program. The NSLS-II RF BPM has been designed to meet all requirements for the NSLS-II Injection system and Storage Ring. Housing of the RF BPMs in ±0.1C thermally controlled racks provide sub-micron stabilization without active correction. An active pilot-tone has been incorporated to aid long-term (8hr min) stabilization to 200nm RMS.

TUP193

NSLS-II Power Supply Controller

1187

W. Louie, L.R. Dalesio, G. Ganetis, Y. Tian
BNL, Upton, Long Island, New York, USA

This paper presents the design of the National Synchrotron Light Source II (NSLS-II) Power Supply Controller (PSC). It consists of a main board, rear module and backplane. The main features of NSLS-II PSC included 256MB DDR2 memory for power supply system diagnostics, high speed serial link between PSC modules, an embedded microprocessor and a 100 Mbps Ethernet port. Each PSC module can be remotely programmed through network. NSLS-II PSC will be used to control power supplies in Storage Ring, Booster Ring and Transport line. The PSC also provides interface for the NSLS-II fast and slow orbits feedback system.

WEODN4

NSLS-II Fast Orbit Feedback with Individual Eigenmode Compensation

1488

Y. Tian, L.-H. Yu
BNL, Upton, Long Island, New York, USA

This paper presents the NSLS-II fast orbit feedback system with individual eigenmode compensation. The fast orbit feedback system is a typical multiple-input and multiple-output (MIMO) system. Traditional singular value decomposition (SVD) based fast orbit feedback systems treat each eigenmode the same and the same compensation algorithm is applied to all the eigenmodes. In reality, a MIMO system will have different frequency responses for different eigenmodes and thus it is desirable to design different compensation for each eigenmode. The difficulty with this approach comes from the large amount of computation that needs to be done within the time budget of the orbit feedback system. We designed and implemented the NSLS-II fast orbit feedback (FOFB) system with individual eigenmode compensation by taking advantage of the parallel computation capability of field programmable gate array (FPGA) chips.

Slides WEODN4 [1.064 MB]

WEP201

Status of NSLS-II Booster

1864

S.M. Gurov, A. Akimov, O. Anchugov, A.M. Batrakov, E.A. Bekhtenev, O.V. Belikov, P.B. Cheblakov, V.P. Cherepanov, A.D. Chernyakin, V.G. Cheskidov, I.N. Churkin, A.N. Dubrovin, A. Erokhin, K. Gorchakov, S.E. Karnaev, G.V. Karpov, V.A. Kiselev, V.V. Kobets, V.V. Kolmogorov, V.M. Konstantinov, A.A. Korepanov, E.A. Kuper, V. Kuzminykh, E.B. Levichev, V.R. Mamkin, A.S. Medvedko, O.I. Meshkov, N. Nefedov, V.V. Neyfeld, I.N. Okunev, M. Petrichenkov, V.V. Petrov, A. Polyansky, D.N. Pureskin, A. Rakhimov, S.I. Ruvinsky, T.V. Rybitskaya, L.M. Schegolev, A.V. Semenov, D.V. Senkov, S.S. Serednyakov, S.V. Shiyankov, D.A. Shvedov, S.V. Sinyatkin, V.V. Smaluk, A.V. Sukhanov, L. Tsukanova, A.V. Utkin, K. Yaminov
BINP SB RAS, Novosibirsk, Russia
J.H. DeLong, R.P. Fliller, G. Ganetis, H.-C. Hseuh, I. Pinayev, T.V. Shaftan, S.K. Sharma, O. Singh, Y. Tian, F.J. Willeke
BNL, Upton, Long Island, New York, USA
P.A.E. Elkiaer
Danfysik A/S, Jyllinge, Denmark

The National Synchrotron Light Source II is a third generation light source under construction at Brookhaven National Laboratory. The project includes a highly optimized 3 GeV electron storage ring, linac pre-injector and full-energy booster-synchrotron. Budker Institute of Nuclear Physics builds booster for NSLS-II. The booster should accelerate the electron beam continuously and reliably from minimal 170 MeV injection energy to maximal energy of 3.15 GeV and average beam current of 20 mA. The booster shall be capable of multi-bunch and single bunch operation. This paper summarizes the status of NSLS-II booster and the main designed parameters.

Paper	Title	Page
MOP198	BPM Inputs to Physics Applications at NSLS-II	465
	Y. Hu, L.R. Dalesio, J.H. DeLong, K. Ha, J. Mead, I. Pinayev, G. Shen, O. Singh, Y. Tian, K. Vetter, L.-H. Yu BNL, Upton, Long Island, New York, USA
	A new BPM (Beam Position Monitor) electronics is under development and in good progress at NSLS-II. This in-house BPM receiver with many new features is comparable to commercial solution. BPM data for fast orbit feedback (FOFB) is one of the most important physics applications. The procedure to use BPM for FOFB is introduced firstly. Then, different BPM data flows associated with different physics requirements and applications are discussed. And control implementation of BPM system for physics applications is presented.

MOP211	NSLS-II RF Beam Position Monitor	495
	K. Vetter, J.H. DeLong, A.J. Della Penna, K.M. Ha, Y. Hu, B.N. Kosciuk, J. Mead, I. Pinayev, O. Singh, Y. Tian BNL, Upton, Long Island, New York, USA G.J. Portmann LBNL, Berkeley, California, USA J.J. Sebek SLAC, Menlo Park, California, USA
	Funding: Work supported by the U.S. DOE under contract No. DE-AC02-98CH10886. An internal R&D program has been undertaken at BNL to develop a sub-micron RF Beam Position Monitor (BPM) for the NSLS-II 3rd generation light source that is currently under construction. The BPM R&D program started in August 2009. Successful beam tests were conducted 15 months from the start of the program. The NSLS-II RF BPM has been designed to meet all requirements for the NSLS-II Injection system and Storage Ring. Housing of the RF BPMs in ±0.1C thermally controlled racks provide sub-micron stabilization without active correction. An active pilot-tone has been incorporated to aid long-term (8hr min) stabilization to 200nm RMS.

TUP193	NSLS-II Power Supply Controller	1187
	W. Louie, L.R. Dalesio, G. Ganetis, Y. Tian BNL, Upton, Long Island, New York, USA
	This paper presents the design of the National Synchrotron Light Source II (NSLS-II) Power Supply Controller (PSC). It consists of a main board, rear module and backplane. The main features of NSLS-II PSC included 256MB DDR2 memory for power supply system diagnostics, high speed serial link between PSC modules, an embedded microprocessor and a 100 Mbps Ethernet port. Each PSC module can be remotely programmed through network. NSLS-II PSC will be used to control power supplies in Storage Ring, Booster Ring and Transport line. The PSC also provides interface for the NSLS-II fast and slow orbits feedback system.

WEODN4	NSLS-II Fast Orbit Feedback with Individual Eigenmode Compensation	1488
	Y. Tian, L.-H. Yu BNL, Upton, Long Island, New York, USA
	This paper presents the NSLS-II fast orbit feedback system with individual eigenmode compensation. The fast orbit feedback system is a typical multiple-input and multiple-output (MIMO) system. Traditional singular value decomposition (SVD) based fast orbit feedback systems treat each eigenmode the same and the same compensation algorithm is applied to all the eigenmodes. In reality, a MIMO system will have different frequency responses for different eigenmodes and thus it is desirable to design different compensation for each eigenmode. The difficulty with this approach comes from the large amount of computation that needs to be done within the time budget of the orbit feedback system. We designed and implemented the NSLS-II fast orbit feedback (FOFB) system with individual eigenmode compensation by taking advantage of the parallel computation capability of field programmable gate array (FPGA) chips.
	Slides WEODN4 [1.064 MB]

WEP201	Status of NSLS-II Booster	1864
	S.M. Gurov, A. Akimov, O. Anchugov, A.M. Batrakov, E.A. Bekhtenev, O.V. Belikov, P.B. Cheblakov, V.P. Cherepanov, A.D. Chernyakin, V.G. Cheskidov, I.N. Churkin, A.N. Dubrovin, A. Erokhin, K. Gorchakov, S.E. Karnaev, G.V. Karpov, V.A. Kiselev, V.V. Kobets, V.V. Kolmogorov, V.M. Konstantinov, A.A. Korepanov, E.A. Kuper, V. Kuzminykh, E.B. Levichev, V.R. Mamkin, A.S. Medvedko, O.I. Meshkov, N. Nefedov, V.V. Neyfeld, I.N. Okunev, M. Petrichenkov, V.V. Petrov, A. Polyansky, D.N. Pureskin, A. Rakhimov, S.I. Ruvinsky, T.V. Rybitskaya, L.M. Schegolev, A.V. Semenov, D.V. Senkov, S.S. Serednyakov, S.V. Shiyankov, D.A. Shvedov, S.V. Sinyatkin, V.V. Smaluk, A.V. Sukhanov, L. Tsukanova, A.V. Utkin, K. Yaminov BINP SB RAS, Novosibirsk, Russia J.H. DeLong, R.P. Fliller, G. Ganetis, H.-C. Hseuh, I. Pinayev, T.V. Shaftan, S.K. Sharma, O. Singh, Y. Tian, F.J. Willeke BNL, Upton, Long Island, New York, USA P.A.E. Elkiaer Danfysik A/S, Jyllinge, Denmark
	The National Synchrotron Light Source II is a third generation light source under construction at Brookhaven National Laboratory. The project includes a highly optimized 3 GeV electron storage ring, linac pre-injector and full-energy booster-synchrotron. Budker Institute of Nuclear Physics builds booster for NSLS-II. The booster should accelerate the electron beam continuously and reliably from minimal 170 MeV injection energy to maximal energy of 3.15 GeV and average beam current of 20 mA. The booster shall be capable of multi-bunch and single bunch operation. This paper summarizes the status of NSLS-II booster and the main designed parameters.