JLab, Newport News, Virginia, USA
RadiaSoft LLC, Boulder, Colorado, USA
BNL, Upton, New York, USA
DESY, Hamburg, Germany
Cornell University, Ithaca, New York, USA
Tech-X, Boulder, Colorado, USA
SLAC, Menlo Park, California, USA
ANL, Lemont, Illinois, USA
ODU, Norfolk, Virginia, USA
Cornell University (CLASSE), Cornell Laboratory for Accelerator-Based Sciences and Education, Ithaca, New York, USA
Douglas Consulting, York, Virginia, USA
Muons, Inc, Illinois, USA
Northern Illinois University, DeKalb, Illinois, USA
Stanford University, Stanford, California, USA
Texas A&M University, College Station, USA
Fermilab, Batavia, Illinois, USA
FRIB, East Lansing, Michigan, USA
CalPoly, San Luis Obispo, California, USA
MIT, Cambridge, Massachusetts, USA
LBNL, Berkeley, California, USA
Dimtel, Redwood City, California, USA
NSCL, East Lansing, Michigan, USA
BNL, Upton, New York, USA
SLAC, Menlo Park, California, USA
Fermilab, Batavia, Illinois, USA
The future electron-ion collider (EIC) aims at an electron-proton luminosity of 1033 to 1034 cm-2 sec-1 and a center-of-mass energy range from 20 to 140 GeV. The eRHIC design has been continuously evolving over a couple of years and has reached a considerable level of maturity. The concept is generally conservative with very few risk items which are mitigated in various ways.
BNL, Upton, New York, USA
The NSLS-II storage ring uses the standard four bump injection scheme to inject beam off axis. BESSY and MAX IV are now using a pulsed multipole magnet as an injection kicker. The injected beam sees a field off axis for injection while the stored beam experiences no field on the magnet axis. The principle advantage of using a pulsed multipole for injection is that the stored beam motion is greatly reduced since the field on axis is negligible. The number of pulsed magnets is reduced from five in the nominal scheme (septum and four bumps) to two or three thereby reducing the possible failure modes. This also eliminates the need to precisely match the pulse shapes of four dipole magnets to achieve minimal stored beam motion outside of the bump. In this paper we discuss two schemes of injecting into the NSLS-II using a pulsed multipole magnet. The first scheme uses a single pulsed multipole located in one cell downstream of the injection septum as the injection kicker. The second scheme uses two pulsed multipoles in the injection straight to perform the injection. We discuss both methods of injection and compare each method.
BNL, Upton, New York, USA
BINP SB RAS, Novosibirsk, Russia
* MBA: http://citeseerx.ist.psu.edu/viewdoc/download?doi=10.1.1.495.2446&rep=rep1&type=pdf
** Complex Bend: Phys. Rev. Accel. Beams 21, 100703 (2018)
BNL, Upton, New York, USA
