Paper | Title | Page |
---|---|---|
TUC01 | Status of the Kurchatov Synchrotron Radiation Source | 55 |
|
||
The Kurchatov synchrotron radiation source goes on to operate in the range of synchrotron radiation from VUV up to hard X-ray. An electron current achieves 150 mA at 2.5 GeV, up to 12 experimental stations may function simultaneously. Improvement of the facility according Federal Program of KSRS modernization is in progress. Two 3 Tesla superconducting wigglers have been installed at main ring at 2019. They were tested with small electron beam current at 2020-2021. Wigglers’ influence on beam parameters is much closed to calculated value. Vacuum system has been upgraded at 2020. In 2021 control system will be completely modified. Manufactoring of third 181 MHz RF generator, new preliminary amplification cascades and new waveguides for all three generators continues in Budker Institute (Novosibirsk). Preparation of great modernization of the whole facility according Federal Program for science infrastructure development has been started. | ||
![]() |
Slides TUC01 [17.060 MB] | |
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUC01 | |
About • | Received ※ 24 September 2021 — Accepted ※ 27 September 2021 — Issued ※ 09 October 2021 | |
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
TUC02 |
Concept of a New Kurchatov Synchrotron Radiation Source | |
|
||
The Kurchatov source of SR has started a project for an upgrade of the accelerator complex based on the existing infrastructure. Instead of the operating 2.5 GeV SR source with a natural emittance of 98 nm-rad, a new 2.5 GeV SR source with a natural emittance less than 3 nm-rad will be built. To ensure its "continuous" operation, a new injection complex (top-up energy injection scheme) - 0.2-2.5 GeV booster synchrotron and 200 MeV linac with transfer lines will be installed. The report gives the concept of the new complex. Also, special attention is paid to the main storage ring operation with insertion devices and problems of electron beam injection in the storage ring at the multi-bunch and single-bunch modes. | ||
![]() |
Slides TUC02 [5.979 MB] | |
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
TUPSB33 | 2.5 GeV Booster Synchrotron for a New Kurchatov Synchrotron Radiation Source | 293 |
|
||
The Project of complete modernization of the current accelerator complex is in progress in the NRC «Kurchatov Institute». A new booster synchrotron is a part of the injection complex for a new 3-d generation synchrotron light source. The booster has to ensure reliable and stable operation of the upgraded main storage ring. The paper presents the final design of the new booster synchrotron and its main parameters. | ||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-TUPSB33 | |
About • | Received ※ 22 September 2021 — Accepted ※ 23 September 2021 — Issued ※ 16 October 2021 | |
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
WEPSC20 | Magnets Design for 2.5 GeV Booster Synchrotron | 386 |
|
||
The Project of complete modernization of the current accelerator complex is in progress in the NRC «Kurchatov Institute». The development of a new booster synchrotron as a part of the injection complex for a new 3-d generation synchrotron light source is included in the Project. The booster synchrotron has 24 dipoles, 60 quadrupoles, 48 sextupoles and 24 correctors. In order to obtain the required field quality, 2D- and 3D-simulations of magnets were carried out. The obtained geometry for each of the magnets is presented in the paper. | ||
DOI • | reference for this paper ※ doi:10.18429/JACoW-RuPAC2021-WEPSC20 | |
About • | Received ※ 18 September 2021 — Revised ※ 23 September 2021 — Accepted ※ 27 September 2021 — Issued ※ 08 October 2021 | |
Cite • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |