A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Kalinin, A.

Paper Title Page
MOPAN108 The FONT4 ILC Intra-train Beam-based Digital Feedback System Prototype 416
  • P. Burrows, G. B. Christian, C. I. Clarke, B. Constance, A. F. Hartin, H. D. Khah, C. Perry, C. Swinson, G. R. White
    JAI, Oxford
  • A. Kalinin
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  • S. Molloy
    SLAC, Menlo Park, California
  We present the design of the FONT4 intra-train beam-based digital position feedback system prototype. The system incorporates a fast analogue beam position monitor front-end signal processor, a digital feedback board, and a fast kicker-driver amplifier. The system latency goal is less than 150ns. We report preliminary results of beam tests at the Accelerator Test Facility (ATF) at KEK using electron bunches separated by c. 150ns.  
MOPAN109 Turnaround Feed-Forward Correction at the ILC 419
  • A. Kalinin
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  • P. Burrows
    JAI, Oxford
  Funding: The Commission of European Communities under 6th Framework Programme "Structuring the European Research Area", contract number RIDS-011899, and by the UK Particle Physics & Astronomy Research Council.

The RTML turnaround feed-forward correction scheme, as proposed in the ILC Baseline Configuration Document, is considered. Instabilities in the challenging Damping Ring extraction kicker system may give rise to betatron bunch-by-bunch jitter and position drift across the bunch train. A system is outlined in which the bunch trajectory is measured with an upstream pair of BPMs and corrected with a pair of downstream fast kickers. The beam turnaround time allows signal processing and calculation of the correction. A feed-forward algorithm is formulated and expressions are derived for the main system parameters and procedures: dynamic range, maximal kicker voltage, gain compression error, BPM resolution, system zero offset stability, BPM-to-kicker matrix measurement, feed-forward gain adjustment. This analysis will enable further consideration of system tolerances, and provides a basis for an engineering design.

WEOBAB01 Electromagnetic Background Tests for the ILC Interaction Point Feedback System 1970
  • P. Burrows, G. B. Christian, C. I. Clarke, B. Constance, A. F. Hartin, H. D. Khah, C. Perry, C. Swinson, G. R. White
    JAI, Oxford
  • R. Arnold, S. Molloy, S. Smith, G. R. White, M. Woods
    SLAC, Menlo Park, California
  • A. Kalinin
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  We present results obtained with the T-488 experiment at SLAC Endstation A (ESA). A material model of the ILC extraction-line design was assembled and installed in ESA. The module includes materials representing the mask, beamline calorimeter, and first extraction quadrupole, encompassing a stripline interaction-point feedback system beam position monitor (BPM). The SLAC high-energy electron beam was used to irradiate the module in order to mimic the electromagnetic (EM) backgrounds expected in the ILC interaction region. The impact upon the performance of the feedback BPM was measured, and compared with detailed simulations of its expected response.  
slides icon Slides  
WEPMN080 Development of Circuits and System Models for the Synchronization of the ILC Crab Cavities 2215
  • A. C. Dexter, G. Burt, R. G. Carter, R. O. Jenkins, M. I. Tahir
    Cockcroft Institute, Lancaster University, Lancaster
  • C. D. Beard, P. Goudket, A. Kalinin, L. Ma, P. A. McIntosh
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  Funding: The Commission of the European Communities under the 6th Framework Programme (Structuring the European Research Area) The UK particle physics and astromony research council.

The ILC reference design report (RDR) recommends a 14 mrad crossing angle for the positron and electron beams at the IP. A matched pair of crab cavity systems are required in the beam delivery system to align both bunches at the IP. The use of a multi-cell, 3.9GHz dipole mode superconducting cavity, derived from the Fermilab CKM cavity. Dipole-mode cavities phased for crab rotation are shifted by 90 degrees with respect to similar cavities phased for deflection. Uncorrelated phase errors of 0.086 degrees (equivalent to 61fs) for the two cavity systems, gives an average of 180nm for the relative deflection of the bunch centers. For a horizontal bunch size of 655nm, a deflection of 180nm reduces the ILC luminosity by 2%. The crab cavity systems are to be placed ~28m apart and their synchronization to within 61fs is on the limit of what is presently achievable. This paper describes the design and testing of circuits and control algorithms under development at the Cockcroft Institute in the UK for proof of principle experiments planned on the ERLP at Daresbury and on the ILCTA test beamline at FNAL. Simulation results for measurement and control systems are also given.

THPMN079 Simulation of ILC Feedback BPM Signals in an Intense Background Environment 2889
  • A. F. Hartin, P. Burrows, G. B. Christian, C. I. Clarke, B. Constance, H. D. Khah, C. Perry, C. Swinson, G. R. White
    JAI, Oxford
  • R. Arnold, S. Molloy, S. Smith, M. Woods
    SLAC, Menlo Park, California
  • A. Kalinin
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  Funding: This work is supported in part by the Commission of the European Communities under the 6th Framework Programme "Structuring the European Research Area", contract number RIDS-011899.

Experiment T-488 at SLAC, End Station A recorded distorted BPM voltage signals and an accurate simulation of these signals was performed. Geant simulations provided the energy and momentum spectrum of the incident spray and secondary emissions, and a method via image charges was used to convert particle momenta and number density into BPM stripline currents. Good agreement was achieved between simulated and measured signals. Further simulation of experiment T-488 with incident beam on axis and impinging on a thin radiator predicted minimal impact due to secondary emission. By extension to worst case conditions expected at the ILC, simulations showed that background hits on BPM striplines would have a negligible impact on the accuracy of beam position measurements and hence the operation of the FONT feedback system

WEOCAB01 Design of the Beam Delivery System for the International Linear Collider 1985
  • A. Seryi, J. A. Amann, R. Arnold, F. Asiri, K. L.F. Bane, P. Bellomo, E. Doyle, A. F. Fasso, L. Keller, J. Kim, K. Ko, Z. Li, T. W. Markiewicz, T. V.M. Maruyama, K. C. Moffeit, S. Molloy, Y. Nosochkov, N. Phinney, T. O. Raubenheimer, S. Seletskiy, S. Smith, C. M. Spencer, P. Tenenbaum, D. R. Walz, G. R. White, M. Woodley, M. Woods, L. Xiao
    SLAC, Menlo Park, California
  • I. V. Agapov, G. A. Blair, S. T. Boogert, J. Carter
    Royal Holloway, University of London, Surrey
  • M. Alabau, P. Bambade, J. Brossard, O. Dadoun
    LAL, Orsay
  • M. Anerella, A. K. Jain, A. Marone, B. Parker
    BNL, Upton, Long Island, New York
  • D. A.-K. Angal-Kalinin, C. D. Beard, J.-L. Fernandez-Hernando, P. Goudket, F. Jackson, J. K. Jones, A. Kalinin, P. A. McIntosh
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  • R. Appleby
    UMAN, Manchester
  • J. L. Baldy, D. Schulte
    CERN, Geneva
  • L. Bellantoni, A. I. Drozhdin, V. S. Kashikhin, V. Kuchler, T. Lackowski, N. V. Mokhov, N. Nakao, T. Peterson, M. C. Ross, S. I. Striganov, J. C. Tompkins, M. Wendt, X. Yang
    Fermilab, Batavia, Illinois
  • K. Buesser
    DESY, Hamburg
  • P. Burrows, G. B. Christian, C. I. Clarke, A. F. Hartin
    OXFORDphysics, Oxford, Oxon
  • G. Burt, A. C. Dexter
    Cockcroft Institute, Warrington, Cheshire
  • J. Carwardine, C. W. Saunders
    ANL, Argonne, Illinois
  • B. Constance, H. Dabiri Khah, C. Perry, C. Swinson
    JAI, Oxford
  • O. Delferriere, O. Napoly, J. Payet, D. Uriot
    CEA, Gif-sur-Yvette
  • C. J. Densham, R. J.S. Greenhalgh
    STFC/RAL, Chilton, Didcot, Oxon
  • A. Enomoto, S. Kuroda, T. Okugi, T. Sanami, Y. Suetsugu, T. Tauchi
    KEK, Ibaraki
  • A. Ferrari
    UU/ISV, Uppsala
  • J. Gronberg
    LLNL, Livermore, California
  • Y. Iwashita
    Kyoto ICR, Uji, Kyoto
  • W. Lohmann
    DESY Zeuthen, Zeuthen
  • L. Ma
    STFC/DL, Daresbury, Warrington, Cheshire
  • T. M. Mattison
    UBC, Vancouver, B. C.
  • T. S. Sanuki
    University of Tokyo, Tokyo
  • V. I. Telnov
    BINP SB RAS, Novosibirsk
  • E. T. Torrence
    University of Oregon, Eugene, Oregon
  • D. Warner
    Colorado University at Boulder, Boulder, Colorado
  • N. K. Watson
    Birmingham University, Birmingham
  • H. Y. Yamamoto
    Tohoku University, Sendai
  The beam delivery system for the linear collider focuses beams to nanometer sizes at the interaction point, collimates the beam halo to provide acceptable background in the detector and has a provision for state-of-the art beam instrumentation in order to reach the physics goals. The beam delivery system of the International Linear Collider has undergone several configuration changes recently. This paper describes the design details and status of the baseline configuration considered for the reference design.  
slides icon Slides