A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z    

Medjidzade, V.

Paper Title Page
TPPT090 Progress of 2-Cell Cavity Fabrication for Cornell ERL Injector 4248
 
  • R.L. Geng, P. Barnes, M. Liepe, V. Medjidzade, H. Padamsee, A.K. Seaman, J. Sears, V.D. Shemelin, N. Sherwood
    Cornell University, Laboratory for Elementary-Particle Physics, Ithaca, New York
 
  Five 1300 MHz superconducting niobium cavities are to be used for the injector of Cornell ERL. The beam power requirement (100 kW each cavity) and the need to minimize emittance dilution due to the cavity structure have important impacts to the design and fabrication of these cavities. We plan to use Conflat stainless-steel flanges brazed to niobium tubes of niobium cavities. The first copper prototy cavity has been built and measured. Most parts for the first niobium cavity have been manufactured also. In this report, we will present the progress of the prototyping copper as well as niobium cavities.  
TPPT094 Design of the CW Cornell ERL Injector Cryomodule 4290
 
  • M. Liepe, S.A. Belomestnykh, R.L. Geng, V. Medjidzade, H. Padamsee, V.D. Shemelin, V. Veshcherevich
    Cornell University, Laboratory for Elementary-Particle Physics, Ithaca, New York
 
  Funding: This work is supported by Cornell University.

The Cornell ERL Prototype injector will accelerate bunches from an electron source to an energy of several MeV, while preserving the ultra-low emittance of the beam. The injector linac will be based on superconducting RF technology with five 2-cell RF cavities operated in cw mode. The beam tubes on one side of the cavities have been enlarged to propagate Higher-Order-Mode power from the cavities to broadband RF ring-absorbers located at 80 K between the cavities. The axial symmetry of these ferrite based absorbers, together with two symmetrically placed input couplers per cavity, avoids transverse on-axis fields, which would cause emittance growth. Each cavity is surrounded by a LHe vessel and equipped with a frequency tuner. The cryomodule provides the support and alignment for the cavity string, the LN cooling of the ferrite loads, and the 2K LHe cryogenic system for the high cw heat load of the cavities. In this paper we give an overview of the ERL injector cryomodule design.