| Paper | Title | Page |
|---|---|---|
| MOPMP007 | Design of a Compact Power Distribution System for the ILC | 436 |
| SUSPFO038 | use link to see paper's listing under its alternate paper code | |
|
||
| The Local power distribution system (LPDS) of the In-ternational Linear Collider (ILC) is constructed to transmit RF power from the 10 MW klystron to 39 cavi-ties. Each eight or nine 9-cell cavities is assembled in one cryomodule. The variable hybrid is used to adjust the power dividing ratio due to the different required power of each cavity and the variable phase shifter is used to compensate the phase drift caused by the variable hybrid. More compact LPDS is expected to be integrated on the cryomodule decreasing financial cost. We re-design the shorter variable hybrid with a margin of power ratio of ±25% and phase shifter of total phase range being 35° for compensating hybrid and on-crest searching. Fixed phase shifters are designed to adjust the phase difference between adjacent cavities for beam acceleration. Simu-lated results of total compact LPDS can meet the re-quirements of ILC. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2019-MOPMP007 | |
| About • | paper received ※ 16 May 2019 paper accepted ※ 20 May 2019 issue date ※ 21 June 2019 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| TUPGW036 | 1 mA Stable Energy Recovery Beam Operation with Small Beam Emittance | 1482 |
|
||
|
A compact energy-recovery linac (cERL) have been operating since 2013 at KEK to develop critical components for ERL facility. Details of design, construction and the result of initial commissioning are already reported*. This paper will describe the details of further improvements and researches to achieve higher averaged beam current of 1 mA with continuous-wave (CW) beam pattern. At first, to keep the small beam emittance produced by 500 kV DC-photocathode gun, tuning of low-energy beam transport is essential. Also, we found some components degrades the beam quality, i.e., a non-metallic mirror which disturbed the beam orbit. Other important aspects are the measurement and mitigation of the beam losses. Combination of beam collimator and tuning of the beam optics can improve the beam halo enough to operate with 1 mA stably. The cERL has been operated with beam energy at 20 MeV or 17.5 MeV and with beam rep-rate of 1300 MHz or 162.5 MHz depending on the purpose of experiments. In each operation, the efficiency of the energy recovery was confirmed to be better than 99.9 %.
* S. Sakanaka, et.al., Nucl. Instr. and Meth. A 877 (2017)197, https://doi.org/10.1016/j.nima.2017.08.051 |
||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2019-TUPGW036 | |
| About • | paper received ※ 14 May 2019 paper accepted ※ 22 May 2019 issue date ※ 21 June 2019 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| THPRB033 | Development Status of RF Reference Phase Stabilization System for SuperKEKB Injector LINAC | 3879 |
|
||
| SuperKEKB injector linear accelerator (LINAC) has 600 m beam lines which consist of 8 sectors. The 2856 MHz RF reference signals are distributed to each sector with long phase stabilized optical fiber (PSOF). The RF reference phase stability requirement is estimated to be 0.2°(RMS) corresponding to 200 fs. The prototype of RF reference phase stabilization system with single mode optical circulator was implemented and demonstrated in the laboratory. The returned phase drift is compensated by a piezo-driven fiber stretcher. The transmitted phase through 120 m PSOF is stabilized to 41 fs (pk-pk), which fulfilled the requirement. This paper introduces the RF reference phase stabilization system and reports the preliminary feedback result. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2019-THPRB033 | |
| About • | paper received ※ 15 May 2019 paper accepted ※ 22 May 2019 issue date ※ 21 June 2019 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| THPTS022 | The Realization of Iterative Learning Control for J-PARC LINAC LLRF Control System | 4155 |
|
||
| The beam current of j-parc linac was planned to increase to 60 mA. The stronger beam current will lead to higher beam loading effect. Due to the low Q factor of cavity in high β section of linac, the traditional PID feedback & feedforward control method may have to face huge challenges. In order to make the system run better at 60 mA, the iterative learning control (ILC) method was put forward to use in LLRF control system. All the ILC operations are done in EPICS-PC. By installing the PyEpics module, we can use python programs to realize the data interaction between EPICS system and PC and further realize the ILC algorithm. In this paper, the architecture of ILC methods will be introduced. The performance of ILC method will be reported. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2019-THPTS022 | |
| About • | paper received ※ 15 May 2019 paper accepted ※ 23 May 2019 issue date ※ 21 June 2019 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |