IPAC2011 - List of Keywords (lepton)

Paper	Title	Other Keywords	Page
TUPC025	Calibration Errors in the Cavity Beam Position Monitor System at the ATF2	cavity, radio-frequency, closed-orbit, simulation	1051
	F.J. Cullinan, S.T. Boogert, N.Y. Joshi, A. Lyapin JAI, Egham, Surrey, United Kingdom
	It has been shown at the Accelerator Test Facility at KEK, that it is possible to run a system of 37 cavity beam position monitors (BPMs) and achieve high working resolution. However, stability of the calibration constants (position scale and radio frequency (RF) phase) over a three/four week running period is yet to be demonstrated. During the calibration procedure, random beam jitter gives rise to a statistical error in the position scale and slow orbit drift in position and tilt causes systematic errors in both the position scale and RF phase. These errors are dominant and have been evaluated for each BPM. The results are compared with the errors expected after a tested method of beam jitter subtraction has been applied.

WEPC052	Spinor Based Calculation of Depolarizing Effects in Circular Lepton Accelerators	synchrotron, resonance, polarization, photon	2130
	O. Boldt, A. Dieckmann, F. Frommberger, W. Hillert ELSA, Bonn, Germany
	Funding: BMBF The emission of synchrotron radiation strongly influences the beam dynamics in case of ultra relativistic leptons. When storing or accelerating leptons in circular accelerators, the acting magnetic field shows an oscillating behavior in the rest frame of the leptons. Its properties can be determined by a spectral analysis. The stochastic emission of synchrotron light leads to a line broadening within the magnetic field spectrum. This spectrum can be used to simulate depolarizing effects in circular accelerators. Our contribution will present a tracking based calculation of the mentioned spectrum and a spinor-based determination of the resulting population of the spin-up state. These calculations base on the lattice of the electron stretcher accelerator (ELSA, Bonn) and are confirmed by measurements of the polarization.

Paper

Title

Other Keywords

Page

TUPC025

Calibration Errors in the Cavity Beam Position Monitor System at the ATF2

cavity, radio-frequency, closed-orbit, simulation

1051

F.J. Cullinan, S.T. Boogert, N.Y. Joshi, A. Lyapin
JAI, Egham, Surrey, United Kingdom

It has been shown at the Accelerator Test Facility at KEK, that it is possible to run a system of 37 cavity beam position monitors (BPMs) and achieve high working resolution. However, stability of the calibration constants (position scale and radio frequency (RF) phase) over a three/four week running period is yet to be demonstrated. During the calibration procedure, random beam jitter gives rise to a statistical error in the position scale and slow orbit drift in position and tilt causes systematic errors in both the position scale and RF phase. These errors are dominant and have been evaluated for each BPM. The results are compared with the errors expected after a tested method of beam jitter subtraction has been applied.

WEPC052

Spinor Based Calculation of Depolarizing Effects in Circular Lepton Accelerators

synchrotron, resonance, polarization, photon

2130

O. Boldt, A. Dieckmann, F. Frommberger, W. Hillert
ELSA, Bonn, Germany

Funding: BMBF
The emission of synchrotron radiation strongly influences the beam dynamics in case of ultra relativistic leptons. When storing or accelerating leptons in circular accelerators, the acting magnetic field shows an oscillating behavior in the rest frame of the leptons. Its properties can be determined by a spectral analysis. The stochastic emission of synchrotron light leads to a line broadening within the magnetic field spectrum. This spectrum can be used to simulate depolarizing effects in circular accelerators. Our contribution will present a tracking based calculation of the mentioned spectrum and a spinor-based determination of the resulting population of the spin-up state. These calculations base on the lattice of the electron stretcher accelerator (ELSA, Bonn) and are confirmed by measurements of the polarization.