IPAC2011 - List of Authors (Gallo, G.)

Paper	Title	Page
TUPS082	The LEBT Chopper for the Spiral 2 Project	1731
	A.C. Caruso, F. Consoli, G. Gallo, D. Rifuggiato, E. Zappalà INFN/LNS, Catania, Italy M. Di Giacomo GANIL, Caen, France A. Longhitano ALTEK, San Gregorio (CATANIA), Italy
	The Spiral 2 driver uses a slow chopper situated in the common section of the low energy beam transport line to change the beam intensity, to cut off the beam in case of critical loss and to avoid hitting the wheel structure of rotating targets. The device has to work up to 10 kV, 1 kHz repetition frequency rate and its design is based on standard power circuits, custom alarm board and vacuum feed-through. The paper summarizes the design principles and describes the test results of the final device which has been installed on the beam line test bench.

Paper

Title

Page

The LEBT Chopper for the Spiral 2 Project

1731

A.C. Caruso, F. Consoli, G. Gallo, D. Rifuggiato, E. Zappalà
INFN/LNS, Catania, Italy
M. Di Giacomo
GANIL, Caen, France
A. Longhitano
ALTEK, San Gregorio (CATANIA), Italy

The Spiral 2 driver uses a slow chopper situated in the common section of the low energy beam transport line to change the beam intensity, to cut off the beam in case of critical loss and to avoid hitting the wheel structure of rotating targets. The device has to work up to 10 kV, 1 kHz repetition frequency rate and its design is based on standard power circuits, custom alarm board and vacuum feed-through. The paper summarizes the design principles and describes the test results of the final device which has been installed on the beam line test bench.