| Paper |
Title |
Page |
| TUPD002 |
Development of an Eddy Current Septum for LINAC4
|
1434 |
| |
- M. J. Barnes, B. Balhan, J. Borburgh, T. Fowler, B. Goddard, W. J.M. Weterings
CERN, Geneva
- A. Ueda
KEK, Ibaraki
|
|
| |
The bump for the new PS Booster injection from the future Linac4 will be made up of a set of four pulsed dipole magnets; the first of these (BS1) must act as a septum with a thin element dividing the high-field region of the circulating beam from the field-free region through which the injected H- beam must pass. BS1 will provide a deflection of 66 mrad at 160 MeV; this will be achieved with a peak field of 630 mT and a length of 200 mm. The field must rise and fall in 40 microseconds and have a flattop of up to 120 microseconds. The ripple of the flattop should be below ±1%. This paper discusses the design of an eddy current septum for BS1.
|
|
| WEPC091 |
Beam Injection by Use of a Pulsed Sextupole Magnet at the Photon Factory Storage Ring
|
2204 |
| |
- H. Takaki, N. Nakamura
ISSP/SRL, Chiba
- K. Harada, T. Honda, Y. Kobayashi, T. Miyajima, S. Nagahashi, T. Obina, A. Ueda
KEK, Ibaraki
|
|
| |
We will install a pulsed sextupole magnet (PSM) in order to test a new injection system for the top-up injection at the Photon Factory storage ring (PF ring) in the spring of 2008. A parabolic magnetic field of the PSM can give an effective kick to the injected beam that passes a distant region from the field center. And there is little modulation of the orbit of the stored beam because it passes around the center of the PSM. To achieve the beam injection at the PF ring, the PSM has a length of 0.3m, a magnetic field of 400 Gauss at a peak current of 3000A and a pulse width of 2.4μsec in a half-sine form. We already made the PSM and measured the magnetic field. We will report the result of the PSM beam injection at the PF ring.
|
|
| WEPC092 |
A Pulsed Quadrupole Magnet Injection at the PF-AR Storage Ring
|
2207 |
| |
- H. Takaki, N. Nakamura
ISSP/SRL, Chiba
- K. Harada, Y. Kobayashi, T. Miyajima, S. Nagahashi, T. Obina, A. Ueda, K. Umemori
KEK, Ibaraki
|
|
| |
We have examined a beam injection system that used a pulsed quadruple magnet (PQM) at the PF-AR storage ring since the spring of 2004. The system is operating well and the accumulation of the beam up to 60mA in the single bunch operation is possible by the current state. The beam injection system that uses the PQM does not require a conventional injection bump orbit, and has the feature that only one PQM in the injection part is needed. An injected beam is kicked to be proportional to the distance from the center and captured afterwards. On the other hand, the pulse kick hardly influences the stored beam at the magnetic field center of the PQM. We report on the result of collecting the basic data of the influence on the PQM beam injection at the PF-AR storage ring.
|
|
| WEPC035 |
Present Status of PF-ring and PF-AR in KEK
|
2064 |
| |
- Y. Kobayashi, S. Asaoka, K. Ebihara, K. Haga, K. Harada, T. Honda, T. Ieiri, M. Izawa, T. Kageyama, T. Kasuga, M. Kikuchi, K. Kudo, H. Maezawa, K. Marutsuka, A. Mishina, T. Mitsuhashi, T. Miyajima, H. Miyauchi, S. Nagahashi, T. T. Nakamura, T. Nogami, T. Obina, K. Oide, M. Ono, T. Ozaki, C. O. Pak, H. Sakai, Y. Sakamoto, S. Sakanaka, H. Sasaki, Y. Sato, M. Shimada, T. Shioya, M. Tadano, T. Tahara, T. Takahashi, S. Takasaki, Y. Tanimoto, M. Tejima, K. Tsuchiya, T. Uchiyama, A. Ueda, K. Umemori, S. Yamamoto, Ma. Yoshida, M. Yoshimoto
KEK, Ibaraki
|
|
| |
In KEK, we have two synchrotron light sources which were constructed in the early 1980s. One is the Photon Factory storage ring (PF-ring) and the other is the Photon Factory advanced ring (PF-AR). The PF-ring is usually operated at 2.5 GeV and sometimes ramped up to 3.0 GeV to provide photons with the energy from VUV to hard X-ray region. The PF-AR is mostly operated in a single-bunch mode of 6.5GeV to provide pulsed hard X-rays. Operational performances of them have been upgraded through several reinforcements. After the reconstruction of the straight section of the PF-ring in 2005, two short-period-gap undulators have been stably operated. They allow us to produce higher brilliant hard X-rays even at the energy of 2.5 GeV. In March 2008, the circular polarized undulator will be installed in the long straight section of 8.9 m. In the PF-AR, new tandem undulators have been operated since September 2006 to generate much stronger pulsed hard X-rays for the sub-ns resolved X-ray diffraction experiments. In this conference, we report present status of the PF-ring and the PF-AR.
|
|