Paper | Title | Page |
---|---|---|
TUPP051 | Coupling Impedance of DAΦNE Upgraded Vacuum Chamber | 1661 |
|
||
The DAΦNE Phi-factory at INFN LNF has been ugraded in the second half of 2007 with a scope to test a recently proposed scheme of crab waist collisions. The vacuum chamber of the collider has been substantially modified: two new low impedance interaction regions have been designed and installed, the new stripline injection kickers have been implemented, the old bellows have been substituted by the new ones and all ion clearing electrodes have been removed. In the paper we present the machine impedance study of these new vacuum chamber components and compare bunch lengthening measurements in the modified DAΦNE with simulation results. | ||
TUPP074 | A New RF Shielded Bellows for the DAΦNE Upgrade | 1706 |
|
||
A new RF shielded bellows, using the technology of omega shaped strip of beryllium copper material, has been developed and tested on the DAΦNE Upgrade*. The RF omega shield is composed by many Be-Cu strips held by an external floating ring**. Thermal power loss on strips can be easily extracted and dissipated allowing high beam current operation. Leakage of beam induced e.m. fields through the RF shield is almost suppressed. Twenty omega bellows were manufactured and installed in the DAΦNE storage rings and showed good properties up to a stored beam current of 700 mA.
*DAΦNE upgrade: A New magnetic and mechanical layout. PAC07. pp. 1466-1468, Albuquerque. |
||
WEXG02 | Crabbed Waist Collisions in DAΦNE and Super-B Design | 1898 |
|
||
The new idea of increasing the luminosity of a collider with crabbed waist collisions and first experimental results from DAΦNE using this concept are presented. Consequences for the design of future factories will be discussed. An outlook to the performance reach with crabbed waist collisions is given, with emphasis on future B Factories. | ||
![]() |
Slides | |
WEPC075 | Recent Results and Future Perspectives of the SPARC Project | 2169 |
|
||
The SPARC project foresees the realization of a high brightness photo-injector to produce a 150-200 MeV electron beam to drive 500 nm FEL experiments in various configurations, a Thomson backscattering source and a plasma accelerator experiment. The SPARC photoinjector is also the test facility for the recently approved VUV FEL project named SPARX. As a first stage of the commissioning a complete characterization of the photoinjector has been accomplished with a detailed study of the emittance compensation process downstream the gun-solenoid system and the demonstration of the emittance oscillation in the drift. The second stage of the commissioning, that is currently underway, foresees a detailed analysis of the beam matching with the linac in order to confirm the theoretically prediction of emittance compensation based on the invariant envelope matching and the demonstration of the velocity bunching technique in the linac. In this paper we report the experimental results obtained so far and the scientific program for the near future. | ||
WEPP036 | DAΦNE Setup and Operation with the Crab-Waist Collision Scheme | 2599 |
|
||
In the second half of 2007 a major upgrade has been implemented on the Frascati DAΦNE collider in order to test the novel idea of Crab Waist collisions. New vacuum chambers and permanent quadrupole magnets have been designed, fabricated and installed to realize the new configuration. At the same time the performances of relevant hardware components, such as fast injection kickers and shielded bellows have been improved relying on new design concepts. The collider has been successfully commissioned in this new configuration. The paper describes the new layout as well as several experimental results about linear and non-linear optics setup and optimization, damping of beam instabilities and discusses the obtained luminosity performances. | ||
WEPP039 | Design of a 1036 cm-2 s-1 Super-B Factory | 2605 |
|
||
Submitted for the High Luminosity Study Group for an Asymmetric Super-B-Factory: Parameters are being studied for a high luminosity e+e- collider operating at the Upsilon 4S that would deliver a luminosity of 1 to 2 x 1036/cm2/s. This collider would use a novel combination of linear collider and storage ring techniques. In this scheme an electron beam and a positron beam are stored in low-emittance damping rings similar to those designed for a Linear Collider (LC) or the next generation light source. A LC style interaction region is included in the ring to produce sub-millimeter vertical beta functions at the collision point. A large crossing angle (±25 mrad) is used at the collision point to allow beam separation. A crab-waist scheme is used to reduce the hourglass effect and restore peak luminosity. Beam currents of about 1.8 A in 1400 bunches can produce a luminosity of 1036/cm2/s with upgrade possibilities. Design parameters and beam dynamics effects are discussed. | ||
WEPP040 | New Low Emittance Lattices for the SuperB Accelerator Project | 2608 |
|
||
New low emittance lattices (1.6 nm at 7 GeV, 2.8 nm at 4 GeV) have been designed for the asymmetric SuperB accelerator aiming at a luminosity of 1036 cm-2 s-1. Main optics features are two alternating arc cells with different horizontal phase advance, in order to decrease beam emittance and allow at the same time for easy chromaticity correction in the arcs. Emittance can be further reduced by a factor of two for luminosity upgrade. New beam parameters have been chosen to fulfill the transparency conditions for 4x7 GeV beams, different from the asymmetric currents used in operating B-Factories. Beam polarization schemes have been studied and will be implemented in the lattice. |