SRF2015 - List of Authors (Kostin, R.A.)

Paper	Title	Page
MOPB024	SRF Cavity Breakdown Calculation Procedure Using FEA-Software	140
	R.A. Kostin, A. Kanareykin Euclid TechLabs, LLC, Solon, Ohio, USA I.V. Gonin Fermilab, Batavia, Illinois, USA E.N. Zaplatin FZJ, Jülich, Germany
	SRF cavity thermal breakdown can be analyzed analytically using thermodynamics equation. This technique is suitable for simple geometries when surface magnetic field variation can be omitted. Thermal radiation effect which is crucial for SRF gun calculations is also hard to implement properly because of complicated geometry. All of these can be overcome by using multiphysics FEA-software. This paper shows the procedure of cavity thermal breakdown calculation in coupled multiphysics analysis with dependable parameters.
Export •	reference for this paper to ※ BibTeX, ※ LaTeX, ※ Text, ※ RIS/RefMan, ※ EndNote (xml)

THPB011	Superconducting Travelling Wave Accelerating Structure Development	1085
	R.A. Kostin, P.V. Avrakhov, A.D. Didenko, A. Kanareykin Euclid TechLabs, LLC, Solon, Ohio, USA T.N. Khabiboulline, Y.M. Pischalnikov, N. Solyak, V.P. Yakovlev Fermilab, Batavia, Illinois, USA
	Funding: Work supported by US Department of Energy # DE-SC0006300 The 3 cell superconducting TW accelerating structure was developed to experimentally demonstrate and to study tuning issues for a new experimental device - the superconducting traveling wave accelerator (STWA), a technology that may prove of crucial importance to the high energy SRF linacs by raising the effective gradient and therefore reducing the overall cost. Recently, a STWA structure with a feedback waveguide has been suggested. The structure was optimized and has phase advance per cell of 105° which provide 24% higher accelerating gradient than in SW cavities. Also STWA structure has no strong sensitivity of the field flatness and its length may be much longer than SW structure. With this presentation, we discuss the current status of a 3-cell L-band SC traveling wave along with the analysis of its tuning issues. Special attention will be paid to feedback loop operation with the two-coupler feed system. We also report on the development and fabrication of a niobium prototype 3-cell SC traveling wave structure to be tested at 2°K in fall 2015.
Export •	reference for this paper to ※ BibTeX, ※ LaTeX, ※ Text, ※ RIS/RefMan, ※ EndNote (xml)

Paper

Title

Page

SRF Cavity Breakdown Calculation Procedure Using FEA-Software

140

R.A. Kostin, A. Kanareykin
Euclid TechLabs, LLC, Solon, Ohio, USA
I.V. Gonin
Fermilab, Batavia, Illinois, USA
E.N. Zaplatin
FZJ, Jülich, Germany

SRF cavity thermal breakdown can be analyzed analytically using thermodynamics equation. This technique is suitable for simple geometries when surface magnetic field variation can be omitted. Thermal radiation effect which is crucial for SRF gun calculations is also hard to implement properly because of complicated geometry. All of these can be overcome by using multiphysics FEA-software. This paper shows the procedure of cavity thermal breakdown calculation in coupled multiphysics analysis with dependable parameters.

Export •

reference for this paper to ※ BibTeX, ※ LaTeX, ※ Text, ※ RIS/RefMan, ※ EndNote (xml)

THPB011

Superconducting Travelling Wave Accelerating Structure Development

1085

R.A. Kostin, P.V. Avrakhov, A.D. Didenko, A. Kanareykin
Euclid TechLabs, LLC, Solon, Ohio, USA
T.N. Khabiboulline, Y.M. Pischalnikov, N. Solyak, V.P. Yakovlev
Fermilab, Batavia, Illinois, USA

Funding: Work supported by US Department of Energy # DE-SC0006300
The 3 cell superconducting TW accelerating structure was developed to experimentally demonstrate and to study tuning issues for a new experimental device - the superconducting traveling wave accelerator (STWA), a technology that may prove of crucial importance to the high energy SRF linacs by raising the effective gradient and therefore reducing the overall cost. Recently, a STWA structure with a feedback waveguide has been suggested. The structure was optimized and has phase advance per cell of 105° which provide 24% higher accelerating gradient than in SW cavities. Also STWA structure has no strong sensitivity of the field flatness and its length may be much longer than SW structure. With this presentation, we discuss the current status of a 3-cell L-band SC traveling wave along with the analysis of its tuning issues. Special attention will be paid to feedback loop operation with the two-coupler feed system. We also report on the development and fabrication of a niobium prototype 3-cell SC traveling wave structure to be tested at 2°K in fall 2015.

Export •

reference for this paper to ※ BibTeX, ※ LaTeX, ※ Text, ※ RIS/RefMan, ※ EndNote (xml)