PAC2013 - List of Authors (Pilipenko, R.V.)

Paper	Title	Page
WEPAC29	CM2, Second 1.3GHz Cryomodule Fabrication at Fermilab	844
	T.T. Arkan, M.H. Awida, P. Berrutti, E. Borissov, C.M. Ginsburg, C.J. Grimm, E.R. Harms, A. Hocker, T.N. Khabiboulline, Y.O. Orlov, T.J. Peterson, R.V. Pilipenko, Y.M. Pischalnikov, K.S. Premo, L. Ristori, W. Schappert, V.P. Yakovlev Fermilab, Batavia, USA
	Funding: US Department of Energy CM2 is the second 1.3GHz Cryomodule assembled at the Cryomodule Assembly Facility (CAF) in Fermi National Accelerator Laboratory. The string has a doublet magnet, beam position monitor and eight cavities. All the cavities are qualified at 35 MV / m gradient at the Horizontal Test Facility before assembly. The dressed cavities were outfitted with magnetic shielding, blade tuner, and the cold mass was assembled based on the Tesla TTF Type III+ cryomodule design. CM2 is currently being installed into the test stand in NML where it will be cooled down and high power tested. CM2 will also be the first cryomodule that an electron beam will be put through at the NML facility. This will be a proof of principle for the planned Advanced Superconducting Test Accelerator (ASTA) facility at NML. This paper describes the assembly steps, the quality assurance methods and the challenges that we experienced during assembly and qualification steps at CAF. De

Paper

Title

Page

CM2, Second 1.3GHz Cryomodule Fabrication at Fermilab

844

T.T. Arkan, M.H. Awida, P. Berrutti, E. Borissov, C.M. Ginsburg, C.J. Grimm, E.R. Harms, A. Hocker, T.N. Khabiboulline, Y.O. Orlov, T.J. Peterson, R.V. Pilipenko, Y.M. Pischalnikov, K.S. Premo, L. Ristori, W. Schappert, V.P. Yakovlev
Fermilab, Batavia, USA

Funding: US Department of Energy
CM2 is the second 1.3GHz Cryomodule assembled at the Cryomodule Assembly Facility (CAF) in Fermi National Accelerator Laboratory. The string has a doublet magnet, beam position monitor and eight cavities. All the cavities are qualified at 35 MV / m gradient at the Horizontal Test Facility before assembly. The dressed cavities were outfitted with magnetic shielding, blade tuner, and the cold mass was assembled based on the Tesla TTF Type III+ cryomodule design. CM2 is currently being installed into the test stand in NML where it will be cooled down and high power tested. CM2 will also be the first cryomodule that an electron beam will be put through at the NML facility. This will be a proof of principle for the planned Advanced Superconducting Test Accelerator (ASTA) facility at NML. This paper describes the assembly steps, the quality assurance methods and the challenges that we experienced during assembly and qualification steps at CAF. De