TUOCN6
ANL, Argonne, USA
LBNL, Berkeley, California, USA
Transverse to longitudinal emittance exchange was proposed in* as a tool for matching of the electron beam phase space to requirements of a possible application. Here we propose a new purpose, namely, use of two consequential emittance exchanges and the focusing telescope for a bunch compression that can be done without the energy chirp in the electron bunch. It allows to move bunch compressor to the end of the linac and thus to reduce the electron peak current in the linac and relax collective effects. It is also possible to have a split action compression when the first part is done inside the low energy part of the linac and the second and final part is done after the linac. We also demonstrate how proposed bunch compressor can be used for frequency up conversion of the energy modulation provided by laser interacting with the electron beam and thus can prepare a significantly higher frequency seed for seeded free-electron lasers. Same approach can be used for a frequency down conversion that can be useful for a generation of a THz radiation. Finally we note that the proposed bunch compression is practically free from destructive effects of coherent synchrotron radiation.
* M. Cornacchia, P. Emma, Phys. Rev. Spec. Topics – Acc. and Beams, 5, 084001(2002).
ANL, Argonne, USA
The proposed x-ray free-electron laser oscillator* requires continuous electron bunches with ultra-low normalized transverse emittance of less than 0.1 micrometer, a bunch charge of 40 pC, an rms uncorrelated energy spread of less than 1.4 MeV, produced at a rate between 1 MHz to 10 MHz. The bunches are to be compressed to an rms length of ~1 ps and accelerated to the final energy of 7 GeV. In this paper, we discuss a design for an ultra-low-emittance injector based on a 325-MHz room-temperature rf cavity and a Cs2Te photocathode. The results of initial optimizations of the beam dynamics with a focus on extracting and preserving ultra-low emittance will be presented.
* K.-J. Kim et al., Phys. Rev. Lett. 100, 244802 (2008).
ANL, Argonne, USA
The Advanced Photon Source is planning [*] to produce a short-pulse x-ray beam by way of rf deflecting cavities that locally impose a y'-t correlation on the stored beam at an insertion device. SPring-8 recently proposed [**] a variation on this scheme whereby the deflecting cavities impose a local y-t correlation on the stored beam. In one case the chirp is in the angle coordinate and in the other case the position coordinate. They both use slits to pass through a "short" portion of the photon beam. The practical limitations for the two schemes are discussed and compared, such as photon source size and angular divergence, storage ring apertures, and slit transmission.
* A. Nassiri et al., these proceedings
** T. Fujita et al., Proc. of IPAC10, p. 39
ANL, Argonne, USA
The laser slicing technique* has been successfully applied at several low- to medium-energy storage ring light sources to create sub-picosecond pulses of x-rays. Application to high-energy storage rings has been considered problematic because of the required average laser power. However, because of on going advances in laser technology, this technique is now within reach at light sources like the Advanced Photon Source (APS), which operates at 7 GeV. In this paper, we analyze the potential performance of laser slicing at the APS, and compare it to alternatives such as deflecting cavities.
* R. W. Schoenlien et al., Science, 287, 2237(2000).
LBNL, Berkeley, California, USA
UCB, Berkeley, California, USA
ANL, Argonne, USA
The Next Generation Light Source (NGLS) is a design concept, under development at LBNL, for a multi‐beamline soft x‐ray FEL array powered by a 2 GeV superconducting linear accelerator, operating with a 1 MHz bunch repetition rate. The CW superconducting linear accelerator is supplied by a high-brightness, high-repetition-rate photocathode electron gun. Electron bunches are distributed from the linac to the array of independently configurable FEL beamlines with nominal bunch rates up to 100 kHz in each FEL, and with even pulse spacing. Individual FELs may be configured for EEHG, HGHG, SASE, or oscillator mode of operation, and will produce high peak and average brightness x-rays with a flexible pulse format, and with pulse durations ranging from sub-femtoseconds to hundreds of femtoseconds.
ANL, Argonne, USA
LBNL, Berkeley, California, USA
JLAB, Newport News, Virginia, USA
The Advanced Photon Source Upgrade project (APS-U) at Argonne includes implementation of Zholents’* deflecting cavity scheme for production of short x-ray pulses. This is a joint project between Argonne National Laboratory, Thomas Jefferson National Laboratory, and Lawrence Berkeley National Laboratory. This paper describes performance characteristics of the proposed source and technical issues related to its realization. Ensuring stable APS storage ring operation requires reducing quality factors of these modes by many orders of magnitude. These challenges reduce to those of the design of a single-cell SC cavity that can achieve the desired operating deflecting fields while providing needed damping of all these modes. The project team is currently prototyping and testing several promising designs for single-cell cavities with the goal of deciding on a winning design in the near future.
*A. Zholents et al., NIM A 425, 385 (1999).
LBNL, Berkeley, California, USA
ANL, Argonne, USA
We report on on-going studies of a superconducting CW linac driver intended to support a high repetition rate FEL operating in the soft x-rays spectrum. We present a point-design for a 1.8 GeV machine tuned for 300~pC bunches and delivering low-emittance, low-energy spread beams as needed for the SASE and seeded beamlines.