Paper | Title | Page |
---|---|---|
WEP212 | Development of a 325 MHz 4-Rod RFQ | 1888 |
|
||
A 4-Rod RFQ with a frequency of 325 MHz and an output energy of 3 MeV will be build as a part of the FAIR project of GSI. Design studies and model measurements on a short prototype of a 325 MHz 4-Rod RFQ model were made including simulations using CST Microwave Studio. The latest simulation results regarding the dipole field of this structure are presented in this paper. | ||
WEP213 | New Development of a RFQ Beam Matching Section | 1891 |
|
||
Funding: BMBF Funneling is a method to increase low energy beam currents in multiple stages. The Frankfurt Funneling Experiment is a model of such a stage. The experiment is built up of two ion sources with electrostatic lens systems, a Two-Beam-RFQ accelerator, a funneling deflector and a beam diagnostic system. The two beams are bunched and accelerated in a Two-Beam RFQ. A funneling deflector combines the bunches to a common beam axis. Current work is the construction and beam tests of a new beam transport system between RFQ accelerator and deflector. With extended RFQ-electrodes the drift between the Two-Beam-RFQ and the rf-deflector will be minimized and therefore unwanted emittance growth reduced. First rf-measurements with the improved Two-Beam-RFQ will be presented. |
||
WEP214 | Tuning Studies on 4-Rod RFQs | 1894 |
|
||
For the optimization of Radio Frequency Quadrupole (RFQ) design parameters, a certain voltage distribution along the electrodes of an RFQ is assumed. Therefore an accurate tuning of the voltage distribution is very important for the beam dynamic properties of an RFQ. A variation can lead to particle losses and reduced beam quality. Our electrode design usually implies a constant longitudinal voltage distribution. For its adjustment tuning plates are used between the stems of the 4-Rod RFQ. Their optimal positions can be found by an iterative process. To structure this tuning process simulations with a NI LabVIEW based Tuning Software and CST Microwave ® are performed and compared to measurements of the ReA3-RFQ of the National Superconducting Cyclotron Laboratory (NSCL) at Michigan State University. The results of this studies are presented in this paper. | ||
WEP226 | Commissioning Results of the ReA RFQ at MSU* | 1912 |
|
||
Funding: Project funded by Michigan State University The Facility for Rare Isotope Beams (FRIB) is currently in the preliminary design phase at Michigan State University (MSU). FRIB consists of a driver LINAC for the acceleration of heavy ion beams, followed by a fragmentation target station and a ReAccelerator facility (ReA3). ReA3 comprises gas stopper systems, an Electron Beam Ion Trap (EBIT) charge state booster, a room temperature radio frequency quadrupole (RFQ), a LINAC using superconducting quarter wave resonators and an achromatic beam transport and distribution line to the new experimental area. Beams from ReA3 will range from 3 MeV/u for heavy ions to about 6 MeV/u for light ions. The ReA3 RFQ, which is of the 4 rod type, is designed to accelerate ions with an Q/A of 0.2 to 0.5 from 12 keV/u to 600 keV/u. The RFQ operates at a frequency of 80.5 MHz and power levels up to 120 kW at 10% duty factor. In this paper we will report on commissioning results from the ReA3 RFQ using a H2+ and He+ beam from an auxiliary ion source. |
||