A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Miura, T.

Paper Title Page
THP106 High Speed Data Acquisition System Using FPGA for LLRF Measurement and Control 1042
  • H. Katagiri, S. Fukuda, T. Matsumoto, S. Michizono, T. Miura, Y. Yano, M. Yoshida
    KEK, Ibaraki

Recently, FPGA technology is widely used for the accelerator control owing to its fast digital processing. We have been developing several applications for LLRF control and measurement using commercial and custom-made FPGA board. XtremeDSP(the commercial FPGA board equipped two ADCs and two DACs) is mainly used for the performance evaluation of STF(Superconducting RF Test Facility) LLRF. Installing the custom-made FPGA board equipped with ten ADCs and two DACs is considering for up-grade of the rf driver and rf monitoring system in the injector linac. Development of the high-speed data acquisition system that combines commercial FPGA board ML555 and FastADC(ADS5474 14bit, 400MS/s) is carried out. Result of those data acquisition systems will be summarized.

THP107 Performance of Digital Low-Level RF Control System with Four Intermediate Frequencies 1045
  • T. Matsumoto, S. Fukuda, H. Katagiri, S. Michizono, T. Miura, Y. Yano
    KEK, Ibaraki

In a superconducting accelerator, an FPGA/DSP-based low-level rf (LLRF) system with feedback control is adopted to satisfy the requirement of stability in the accelerating field. An rf probe signal picked up from cavity is down-converted to an intermediate frequency and sampled by an analog-to-digital converter (ADC) in the digital LLRF control system. In order to decrease the number of the ADCs required for vector sum feedback operation, a digital LLRF control system using different intermediate frequencies has been developed. At STF (Superconducting RF Test Facility) in KEK, the digital LLRF system with four intermediate frequencies was operated and the rf field stability under the feedback operation was estimated using a superconducting cavity. The result of the performance will be reported.

THP108 Performance of Digital LLRF System for STF in KEK 1048
  • S. Michizono, S. Fukuda, H. Katagiri, T. Matsumoto, T. Miura, Y. Yano
    KEK, Ibaraki

RF operation has started at the STF (Superconducting RF Test Facility) in KEK. The digital feedback system, which consists of one FPGA, ten 16-bit ADCs and two 14-bit DACs, was installed in order to satisfy the rf-field regulation requirements of 0.3% rms and 0.3 deg.rms in phase. The rf field stability under various feedback parameters are presented. Various studies were also carried out such as cavity detuning measurements (microphonics, quench detection, etc.). These results will also be summarized.

THP109 Measurements of Feedback-Instability Due to 8/9π and 7/9π Modes at KEK-STF 1051
  • T. Miura, S. Fukuda, H. Katagiri, T. Matsumoto, S. Michizono, Y. Yano
    KEK, Ibaraki

In the superconducting rf test facility (STF) at KEK, high power tests of the nine-cell superconducting cavity for the international linear collider (ILC) have been performed. Although the cavity was operated in π-mode, the feedback instability due to 8/9π and 7/9π modes was observed in the STF. The intensities of 8/9π and 7/9π modes were measured by changing the feedback loop-delay and stable/unstable region appeared periodically as expected.