| Paper | Title | Page |
|---|---|---|
| MOPRO001 | Upgrade Status of Injector LINAC for SuperKEKB | 59 |
|
||
| The SuperKEKB collider is under construction to achieve 40-times higher luminosity than that of previous KEKB collider. The injector LINAC should provide high-intensity and low-emittance beams of 7-GeV electron and 4-GeV positron for SuperKEKB based on a nano-beam scheme. A photocathode RF-gun for low emittance electron beam has been already installed and the commissioning has started. The construction of positron capture section using a flux-concentrator and the dumping ring for low emittance positron beam is in progress. The simultaneous top-up injections to four storage-rings including photon factories is also required. In the upstream of dumping ring, the compatible optics between positron and electron has been designed. In the downstream of dumping ring, RF phase, focusing, and steering magnets will be switched by pulse to pulse against each beam-mode for optimising beam-transportation. This paper describes recent upgrade status toward the SuperKEKB. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-MOPRO001 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| MOPRI004 | SuperKEKB Positron Source Construction Status | 579 |
|
||
| The KEKB positron source is under the upgrade for SuperKEKB. The previous positron production target and capture section have been removed and the new system is constructed at a location forty meters upstream to have sufficient energy margin for beam injection to the newly introduced damping ring. A flux concentrator is introduced in the new capture section to make an adiabatic matching system. Large aperture (30mm in diameter) S-band accelerating structures are introduced in the capture section and in the subsequent accelerator module to enlarge the transverse phase space acceptance. The beam focusing system of quadrupoles is also upgraded for a comparable beam acceptance to that of the capture section. This paper reports on the status of the SuperKEKB positron source construction and the preliminary positron beam commissioning. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-MOPRI004 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| WEOAB02 | Wide-band Induction Acceleration in the KEK Digital Accelerator | 1893 |
| SUSPSNE021 | use link to see paper's listing under its alternate paper code | |
|
||
|
Induction synchrotron can accelerate any ion species directly to higher energy without a large pre-accelerator, due to its intrinsic nature that there is no frequency band-width limitation below 1 MHz. KEK digital accelerator (DA) is a small scale prototype of fast cycling induction synchrotron. Recently it has been confirmed that heavy ion beams of mass to charge ratio A/Q = 4 are stably accelerated from 200 keV to a few tens of MeV in this accelerator ring*, where the revolution frequency changes from82 kHz to 1 MHz. Acceleration and beam confinement are separately realized by pulse voltages generated in induction cells (1 to 1 pulse transformers) driven by the switching power supply (SPS)**. Everything is simply maneuvered by controlling of gate signals of solid-state switching elements employed in the SPS. For this purpose, the fully programmed acceleration control system based on the FPGA has been developed. In this paper, the wide-band induction acceleration is presented with experimental results. Further possibilities of beam handling in the induction synchrotron, such as super bunch and novel beam handling techniques, are discussed.
* K.Takayama et al., to be submitted to Phys. Rev. Lett. (2013). ** T.Iwashita et al., Phys. Rev. ST-AB 14, 071301(2011). |
||
|
Slides WEOAB02 [8.935 MB] | |
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-WEOAB02 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |