IPAC2014 - List of Authors (Gudkov, D.)

Paper	Title	Page
THPRI052	Design, Fabrication and Tests of the Second Prototype of the Double-Length CLIC PETS	3887
	L. Sánchez, J. Calero, D. Gavela, J.L. Gutiérrez, F. Toral CIEMAT, Madrid, Spain D. Gudkov, G. Riddone CERN, Geneva, Switzerland
	Funding: This work has been partially funded by the Spanish Ministry of Economy and Competitiveness under project FPA2010-21456-C02-02 The future collider CLIC is based on a two-beam acceleration scheme, where the drive beam provides to the main beam the RF power through the Power Extraction and Transfer Structures (PETS). The technical feasibility of some components is currently being proved at the CLIC Experimental Area (CLEX). Two double- length CLIC PETS will be installed in CLEX to validate their performance with beam. The first prototype was produced and validated in 2012. This paper is focused on the engineering design, fabrication and validation of the second prototype. Taking into account the results of the first prototype, some modifications have been included in the design to ease fabrication and assembly. The fabrication techniques are very similar to the ones used for the first prototype. Mechanical measurements on single parts and different assembly stages will be reported. The industrialization feasibility will be also analyzed. Finally, several tests such as vacuum tightness and RF measurements with low power have been realized to validate the device. These results are compared with the first prototype ones.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-THPRI052
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

Design, Fabrication and Tests of the Second Prototype of the Double-Length CLIC PETS

3887

L. Sánchez, J. Calero, D. Gavela, J.L. Gutiérrez, F. Toral
CIEMAT, Madrid, Spain
D. Gudkov, G. Riddone
CERN, Geneva, Switzerland

Funding: This work has been partially funded by the Spanish Ministry of Economy and Competitiveness under project FPA2010-21456-C02-02
The future collider CLIC is based on a two-beam acceleration scheme, where the drive beam provides to the main beam the RF power through the Power Extraction and Transfer Structures (PETS). The technical feasibility of some components is currently being proved at the CLIC Experimental Area (CLEX). Two double- length CLIC PETS will be installed in CLEX to validate their performance with beam. The first prototype was produced and validated in 2012. This paper is focused on the engineering design, fabrication and validation of the second prototype. Taking into account the results of the first prototype, some modifications have been included in the design to ease fabrication and assembly. The fabrication techniques are very similar to the ones used for the first prototype. Mechanical measurements on single parts and different assembly stages will be reported. The industrialization feasibility will be also analyzed. Finally, several tests such as vacuum tightness and RF measurements with low power have been realized to validate the device. These results are compared with the first prototype ones.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-THPRI052

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)