IPAC2014 - List of Authors (Frasciello, O.)

Paper	Title	Page
TUPRI049	Geometric Beam Coupling Impedance of LHC Secondary Collimators	1677
SUSPSNE059	use link to see paper's listing under its alternate paper code
	O. Frasciello, S. Tomassini, M. Zobov INFN/LNF, Frascati (Roma), Italy A. Grudiev, N. Mounet, B. Salvant CERN, Geneva, Switzerland
	Funding: Work supported by European Commission within the Framework Programme 7 Capacities Specific Programme, Grant Agreement 284404 The High Luminosity LHC project is aimed at increasing the LHC luminosity by an order of magnitude. One of the key ingredients to achieve the luminosity goal is the beam intensity increase. In order to keep under control beam instabilities and to avoid excessive power losses a careful design of new vacuum chamber components and an improvement of the present LHC impedance model are required. Collimators are the main impedance contributors. Measurements with beam have revealed that the betatron coherent tune shifts were by about a factor of 2 higher with respect to the theoretical predictions based on the current model. Up to now the resistive wall impedance has been considered as the major impedance contribution for collimators. By carefully simulating their geometric impedance we show that for the graphite collimators with half-gaps higher than 10 mm the geometric impedance exceeds the resistive wall one. In turn, for the tungsten collimators the geometric impedance dominates for all used gap values. Hence, including the geometric collimator impedance into the LHC impedance model enabled us to reach a better agreement between the measured and simulated collimator tune shifts.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-TUPRI049
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

WEOCA03	DAΦNE Operation with the Upgraded KLOE-2 Detector	1883
	C. Milardi, D. Alesini, M.E. Biagini, M. Boscolo, B. Buonomo, S. Cantarella, A. De Santis, G.O. Delle Monache, G. Di Pirro, A. Drago, L.G. Foggetta, O. Frasciello, A. Gallo, A. Ghigo, F. Guatieri, S. Guiducci, F. Iungo, C. Ligi, G. Mazzitelli, L. Pellegrino, R. Ricci, U. Rotundo, C. Sanelli, G. Sensolini, M. Serio, A. Stecchi, A. Stella, M. Zobov INFN/LNF, Frascati (Roma), Italy R. Gargana, A. Michelotti Consorzio Laboratorio Nicola Cabibbo, Frascati, Italy D.N. Shatilov BINP SB RAS, Novosibirsk, Russia M. Tobiyama KEK, Ibaraki, Japan A. Valishev Fermilab, Batavia, Illinois, USA
	The DAΦNE collider has been successfully commissioned after the experimental detector modification and a major upgrade and consolidation program involving a large part of the accelerator complex. This paper presents the Φ-Factory setup and the achieved performances in terms of beam currents, luminosity, detector background and related aspects.
	Slides WEOCA03 [2.424 MB]
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-WEOCA03
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

THPRI002	DAΦNE General Consolidation and Upgrade	3760
	C. Milardi, D. Alesini, S. Bini, B. Buonomo, S. Cantarella, A. De Santis, G.O. Delle Monache, G. Di Pirro, A. Drago, L.G. Foggetta, O. Frasciello, A. Gallo, A. Ghigo, F. Iungo, C. Ligi, L. Pellegrino, R. Ricci, U. Rotundo, C. Sanelli, G. Sensolini, A. Stecchi, A. Stella, M. Zobov INFN/LNF, Frascati (Roma), Italy R. Gargana, A. Michelotti Consorzio Laboratorio Nicola Cabibbo, Frascati, Italy
	In the first six months of 2013 the KLOE detector has been upgraded inserting new detector layers in the inner part of the apparatus, around the interaction region. The long shutdown has been used to undertake a general consolidation program aimed at improving the Φ-Factory operation stability and reliability and, in turn, the collider uptime. In this context several systems have been revised and upgraded, new diagnostic elements have been installed, some critical components have been modified and the interaction region mechanical support structure design has been developed to improve its mechanical stability and to deal with the weight added by the new detector layers.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-THPRI002
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

TUPRI049

Geometric Beam Coupling Impedance of LHC Secondary Collimators

1677

SUSPSNE059

use link to see paper's listing under its alternate paper code

O. Frasciello, S. Tomassini, M. Zobov
INFN/LNF, Frascati (Roma), Italy
A. Grudiev, N. Mounet, B. Salvant
CERN, Geneva, Switzerland

Funding: Work supported by European Commission within the Framework Programme 7 Capacities Specific Programme, Grant Agreement 284404
The High Luminosity LHC project is aimed at increasing the LHC luminosity by an order of magnitude. One of the key ingredients to achieve the luminosity goal is the beam intensity increase. In order to keep under control beam instabilities and to avoid excessive power losses a careful design of new vacuum chamber components and an improvement of the present LHC impedance model are required. Collimators are the main impedance contributors. Measurements with beam have revealed that the betatron coherent tune shifts were by about a factor of 2 higher with respect to the theoretical predictions based on the current model. Up to now the resistive wall impedance has been considered as the major impedance contribution for collimators. By carefully simulating their geometric impedance we show that for the graphite collimators with half-gaps higher than 10 mm the geometric impedance exceeds the resistive wall one. In turn, for the tungsten collimators the geometric impedance dominates for all used gap values. Hence, including the geometric collimator impedance into the LHC impedance model enabled us to reach a better agreement between the measured and simulated collimator tune shifts.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-TUPRI049

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

WEOCA03

DAΦNE Operation with the Upgraded KLOE-2 Detector

1883

C. Milardi, D. Alesini, M.E. Biagini, M. Boscolo, B. Buonomo, S. Cantarella, A. De Santis, G.O. Delle Monache, G. Di Pirro, A. Drago, L.G. Foggetta, O. Frasciello, A. Gallo, A. Ghigo, F. Guatieri, S. Guiducci, F. Iungo, C. Ligi, G. Mazzitelli, L. Pellegrino, R. Ricci, U. Rotundo, C. Sanelli, G. Sensolini, M. Serio, A. Stecchi, A. Stella, M. Zobov
INFN/LNF, Frascati (Roma), Italy
R. Gargana, A. Michelotti
Consorzio Laboratorio Nicola Cabibbo, Frascati, Italy
D.N. Shatilov
BINP SB RAS, Novosibirsk, Russia
M. Tobiyama
KEK, Ibaraki, Japan
A. Valishev
Fermilab, Batavia, Illinois, USA

The DAΦNE collider has been successfully commissioned after the experimental detector modification and a major upgrade and consolidation program involving a large part of the accelerator complex. This paper presents the Φ-Factory setup and the achieved performances in terms of beam currents, luminosity, detector background and related aspects.

Slides WEOCA03 [2.424 MB]

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-WEOCA03

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

THPRI002

DAΦNE General Consolidation and Upgrade

3760

C. Milardi, D. Alesini, S. Bini, B. Buonomo, S. Cantarella, A. De Santis, G.O. Delle Monache, G. Di Pirro, A. Drago, L.G. Foggetta, O. Frasciello, A. Gallo, A. Ghigo, F. Iungo, C. Ligi, L. Pellegrino, R. Ricci, U. Rotundo, C. Sanelli, G. Sensolini, A. Stecchi, A. Stella, M. Zobov
INFN/LNF, Frascati (Roma), Italy
R. Gargana, A. Michelotti
Consorzio Laboratorio Nicola Cabibbo, Frascati, Italy

In the first six months of 2013 the KLOE detector has been upgraded inserting new detector layers in the inner part of the apparatus, around the interaction region. The long shutdown has been used to undertake a general consolidation program aimed at improving the Φ-Factory operation stability and reliability and, in turn, the collider uptime. In this context several systems have been revised and upgraded, new diagnostic elements have been installed, some critical components have been modified and the interaction region mechanical support structure design has been developed to improve its mechanical stability and to deal with the weight added by the new detector layers.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2014-THPRI002

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)