Paper | Title | Page |
---|---|---|
MOPEA019 | Studies of Bunch-bunch Interactions in the ANKA Storage Ring with Coherent Synchrotron Radiation using an Ultra-fast Terahertz Detection System | 109 |
|
||
Funding: Supported by Initiative and Networking Fund of the Helmholtz Association under contract No. VH-NG-320 and German Federal Ministry of Education and Research under Grant. Noss. 05K10VKC and 05K2010VKD In the low-alpha operation mode of the ANKA synchrotron light source, coherent synchrotron radiation (CSR) is emitted from short electron bunches. Depending on the bunch current, the radiation shows bursts of high intensity. These bursts of high intensity THz radiation display a time evolution which can be observed only on long time scales with respect to the revolution period. In addition, long range wake fields can introduce a correlation between the bunches within a bunch train and thus modify the observed behavior. A novel detection system consisting of an ultra-fast superconducting THz detector and data acquisition system was used to investigate correlations visible on the bursting pattern and to study the interactions of very short pulses in the ANKA storage ring. |
||
WEOBB202 | Ultra-fast Data Acquisition System for Coherent Synchrotron Radiation Based on Superconducting Terahertz Detectors | 2094 |
|
||
The ANKA synchrotron radiation source located at the Karlsruhe Institute of Technology in Germany operates in the energy range between 0.5-2.5GeV and provides coherent synchrotron radiation. To resolve the ultra-short terahertz pulses emitted by a single bunch, thin YBCO superconducting film detectors have been developed. A response time of 45ps was determined as the FWHM at the output of the analog amplifier. A novel and high accuracy data acquisition architecture for sampling of the individual ultra-short terahertz pulses combined with real-time data processing based on GPUs for coherent synchrotron radiation is presented. The digitizer board is a made-in-house board designed for sampling of the fast pulse signals with pulse width between few tens of picosecond until 100ps. For each terahertz pulse five samples are acquired with a minimum sampling time of 3ps. A prototype setup with terahertz YBCO detectors, digitizer boards and the high-throughput FPGA framework has been successfully developed and tested at ANKA. The overview of the experimental setup including the YBCO detector technology and the preliminary results with single and multi-bunch filling pattern will be discussed. | ||
![]() |
Slides WEOBB202 [2.416 MB] | |