IHEP, Beijing, People's Republic of China
C-ADS Injector-I is a 10 mA 10 MeV CW proton linac. It uses a 3.2MeV normal conducting 4-Vane RFQ and 12 superconducting single-Spoke cavities. According to the detailed sensitivity analysis of alignment and RF errors, the error tolerance of both static and dynamic ones for Injector-I are presented. The simulation results show that with the error tolerance there are beam losses, the residual orbit is too large which will produce significant emittance growth, so the correction is necessary for Injector-I. After detailed numerical studies, a correction scheme and monitor distributions are proposed. After correction the RMS residual orbit can be controlled within 0.4mm and RMS emittance growth can be controlled within 10%, but it still has 1.7×10-6 beam loss, which comes from the RF errors and low longitudinal acceptance. According to detailed analysis and simulations with 108 macro particles, as a consequence, longitudinal emittance control and longitudinal distribution control as well as large longitudinal acceptance are the key to minimizing beam losses in low energy section. To minimize beam loss, a short period Injector-I lattice with larger longitudinal acceptance have been designed and performance very good error tolerance.
IHEP, Beijing, People's Republic of China
Two design schemes for the main linac of C-ADS (China Accelerator Driven Subcritical system) are presented in this paper. They are corresponding to two different injector schemes. Injector-II scheme makes use of room-temperature RFQ and superconducting HWR cavities with the RF frequency of 162.5 MHz; Injector-I scheme makes use of higher-energy RFQ and superconducting spoke cavities with the RF frequency of 325 MHz. At the first choice, a relatively smaller longitudinal emittance is adopted for the RFQ designs with both the injector schemes to obtain more efficient acceleration. However, compared with the injector-I scheme, with the injector-II scheme, bunch current will be doubled in the main linac due to the half RF frequency in the injector-II. This means stronger space charge effects. Alternate design for the main linac with the injector-II scheme is to increase the longitudinal emittance by 50% so that the space charge effects will be alleviated. However, totally 30 cavities more and 36 m longer in the main linac have to be paid for this design scheme. The design considerations, the lattice designs, the simulation results including halo information are presented.
Private Address, Beijing, People's Republic of China
IHEP, Beijing, People's Republic of China
An ADS study program is approved by Chinese Academy of Sciences at 2011, which aims to design and built an ADS demonstration facility with the capability of more than 1000 MW thermal power within the following 25 years. The 15 MW driver accelerator will be designed and constructed by the Institute of High Energy Physics (IHEP) and Institute of Modern Physics (IMP) of China Academy of Sciences. This linac is characterized by the 1.5 GeV energy, 10 mA current and CW operation. It is composed by two parallel 10 MeV injectors and a main linac integrated with fault tolerance design. The superconducting acceleration structures are employed except the RFQ. The general considerations and the beam dynamics design of the driver accelerator will be presented.
