A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Loos, H.

Paper Title Page
MOPC14 LCLS X-Ray Pulse Duration Measurement Using the Statistical Fluctuation Method 147
 
  • J. Wu, Y.T. Ding, P. Emma, Z. Huang, H. Loos, M. Messerschmidt
    SLAC, Menlo Park, California
  • E. Schneidmiller, M.V. Yurkov
    DESY, Hamburg
 
 

For a SASE-FEL, the FEL pulse energy fluctuates from shot to shot, because the lasing process starts up from shot noise. When operating in the exponential growth regime, the radiation exhibits the properties of completely chaotic polarized light. Hence, the probability distribution of the FEL pulse energy follows a gamma distribution. Based on the measurement of such a distribution function, one can calculate the average number of ‘degrees of freedom’ or ‘modes’ in the radiation pulse. Thus, one can measure the FEL pulse temporal duration. In this paper, we report experimental results at LCLS. Measurements are conducted for both nominal charge (250 pC) and low charge (20 pC) cases. For both cases, results are obtained for different undulator lengths and various electron peak current settings.

 
TUOB4 Second and Third Harmonic Measurements at the Linac Coherent Light Source 206
 
  • D.F. Ratner, A. Brachmann, F.-J. Decker, Y.T. Ding, D. Dowell, P. Emma, J.C. Frisch, Z. Huang, R.H. Iverson, J. Krzywinski, H. Loos, M. Messerschmidt, H.-D. Nuhn, T.J. Smith, J.L. Turner, J.J. Welch, W.E. White, J. Wu
    SLAC, Menlo Park, California
  • R.M. Bionta
    LLNL, Livermore, California
 
 

The Linac Coherent Light Source (LCLS) is a Free Electron Laser (FEL) operating with a fundamental wavelength ranging from 1.5-0.15 nm. Characterization of the higher harmonics present in the beam is important to users, for whom harder X-rays can either extend the useful operating wavelength range or represent a background to measurements. We present here measurements of the power in both the second and third harmonics.

 

slides icon

Slides

 
WEPB33 A Demonstration of Multi-bunch Operation in the LCLS 467
 
  • F.-J. Decker, R. Akre, A. Brachmann, Y.T. Ding, D. Dowell, P. Emma, A.S. Fisher, J.C. Frisch, A. Gilevich, P. Hering, Z. Huang, R.H. Iverson, H. Loos, M. Messerschmidt, H.-D. Nuhn, D.F. Ratner, W.F. Schlotter, T.J. Smith, J.L. Turner, J.J. Welch, W.E. White, J. Wu
    SLAC, Menlo Park, California
 
 

The Linac Coherent Light Source at SLAC is a hard X-ray FEL which was designed for single electron bunch operation. Although most user experiments are not interested in multiple bunches from an S-band linac due to their short (ns) separation, there are some advantages with multi-bunch operation. Starting with two bunches where the delayed light of one bunch is used to seed the light of a second bunch, to many more bunches to increase the likelihood of rare target collisions, multi-bunch operation would open more options for the LCLS. In the past the SLAC Linac has operated with a few dedicated bunches for the SLC (Stanford Linear Collider), and up to 1400 bunches for some fixed target experiments, so a few bunches for the LCLS seems possible even with the original single bunch design. This paper will describe how the current RF implementation supports multi-bunch operation. Initial experimental tests with two bunches are presented.

 
THOCI2 Characterization of Second Harmonic Afterburner Radiation at the LCLS* 690
 
  • H.-D. Nuhn, F.-J. Decker, Y.T. Ding, P. Emma, J.C. Frisch, Z. Huang, R.H. Iverson, Yu.I. Levashov, H. Loos, M. Messerschmidt, D.F. Ratner, J.L. Turner, J.J. Welch, Z.R. Wolf, J. Wu
    SLAC, Menlo Park, California
 
 

During undulator commissioning of the Linac Coherent Light Source (LCLS) x-ray Free Electron Laser (FEL) at the SLAC National Accelerator Laboratory it was shown that saturation lengths much shorter than the installed length of the undulator line can routinely be achieved. This frees undulator segments that can be used to provide enhanced spectral properties and at the same time, test the concept of FEL Afterburners. In December 2009 a project was initiated to convert undulator segments at the down-beam end of the undulator line into Second Harmonic Afterburners (SHAB) to enhance LCLS radiation levels in the 10 – 20 keV energy range. This is being accomplished by replacement of gap-shims increasing the fixed gaps from 6.8 mm to 9.9 mm, which reduces their K values from 3.50 to 2.25 and makes the segments resonant at the second harmonic of the upstream unmodified undulators. The paper reports experimental results of the commissioning of the SHAB extension to LCLS.

 

slides icon

Slides