TUIDLH1037
HZDR, Dresden, Germany
JLab, Newport News, Virginia, USA
HZDR, Dresden, Germany
| Paper | Title | Page |
|---|---|---|
TUIDLH1037 |
Commissioning and First RF Results of the 2nd 3.5 Cell SRF Gun for ELBE | |
|
||
| As in 2007 the first 3.5 cell superconducting radio frequency (SRF) gun was taken into operation at Helmholtz-Zentrum Dresden-Rossendorf, it turned out that the specified performance to realize an electron energy of 9.4 MeV has not been achieved. Instead, the resonator of the gun was limited by field emission to about one third of this value and the measured beam parameters remained significantly below its expectations. However, to demonstrate the full potential of this electron source for the ELBE linear accelerator, a second and slightly modified SRF gun was developed and built in collaboration with Thomas Jefferson National Accelerator Facility. We will report on commissioning and first RF results of this new SRF gun. This includes in particular the characterization of the most important RF properties as well as their comparison with previous vertical test results. Additionally, investigations are presented that try to explain a particle contamination that happened recently during the first cathode transfer. | ||
|
|
Slides TUIDLH1037 [9.538 MB] | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| TUIDLH1038 | First Beam Characterization of SRF Gun II with a Copper Photocathode | 42 |
|
||
| An improved SRF gun has been installed and commissioned at HZDR since 2014. This new gun replaces the first SRF gun at the superconducting linear accelerator ELBE which had been in operation since 2007. The new SRF gun II has an improved 3.5-cell niobium cavity and a superconducting solenoid inside the gun cryostat. The gun has been tested first with a Cu photocathode. Using the standard high repetition rate laser system, this allows low bunch charge beams of a few pC only. The beam parameters for these low charges have been measured, and the first beam has been guided into the ELBE accelerator. Since 2015 the photocathode transfer system is installed for future use of Cs2Te photocathodes with high quantum efficiency photocathodes. | ||
|
|
Slides TUIDLH1038 [7.973 MB] | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |