| Paper | Title | Page |
|---|---|---|
| MOPMF039 | First Xenon-Xenon Collisions in the LHC | 180 |
|
||
| In 2017, the CERN accelerator complex once again demonstrated its flexibility by producing beams of a new ion species, xenon, that were successfully injected into LHC. On 12 October, collisions of fully stripped xenon nuclei were recorded for the first time in the LHC at a centre-of-mass energy per colliding nucleon pair of 5.44 TeV. Physics data taking started 9.5 h after the first injection of xenon beams and lasted a total of 6 h. The integrated luminosity delivered to the four LHC experiments was sufficient that new physics results can be expected soon. We provide a general overview of this Xe-Xe pilot run before focussing on beam data at injection energy and at flat-top. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-MOPMF039 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| MOPMF050 | LHC Operational Experience of the 6.5 TeV Proton Run with ATS Optics | 216 |
|
||
| In May 2017, the CERN Large Hadron Collider (LHC) restarted operations at 6.5 TeV using the Achromatic Telescopic Squeeze (ATS) scheme with a target beta-star of 40 cm in ATLAS and CMS. The number of bunches was progressively increased to a maximum of 2556 with emittances of 2.5 um. In August, several machine parameters had to be re-tuned to mitigate beam loss induced instabilities and maintain a steady increase of the instantaneous luminosity. The use of a novel beam type and filling pattern produced in the injectors, allowed filling the machine with very low emittance beam (1.5 um) achieving an equivalent luminosity with 1868 bunches. In September, the beta-star was further lowered to 30 cm (using, for the first time, the telescopic technique of the ATS) and the bunch intensity pushed to 1.25·1011 protons. In the last 3 months of 2017, the LHC produced more than 500 pb-1 of integrated luminosity per day, delivering to each of the high luminosity experiments 50.6 fb-1, 10% above the 2017 target. A general overview of the operational aspects of the 2017 proton run will be presented. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-MOPMF050 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| MOPMF051 | LHC Operational Scenarios During 2017 Run | 220 |
|
||
| During 2017, the Large Hadron Collider LHC delivered luminosity for different physics configuration in addtion to the nominal 6.5 TeV proton-proton run. About 18.5 days were dedicated to commission and to deliver special physics to the experiments. Condifurations with large beta-star of 19 m and 24 m were prepared for luminosity calibration with Van de Meer scans. A proton-proton run at 2.51 TeV took place during the last weeks of November to provide reference data for the heavy ion (Pb-Pb, p-Pb) collisions at the same equivalent nucleon energy . A very short (0.5 days) but effective ion run was scheduled where the LHC saw the first Xe beams collissions and delivered around 3 ub-1 to ATLAS and CMS. The run ended with a low event pile-up run at 6.5TeV. This contribution summarizes the operational aspects and delivered targets for the different configurations. | ||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-MOPMF051 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |
| MOPMF060 | Safe Disposal of the LHC Beam without Beam Dump - Method and Experimental Verification | 253 |
|
||
|
Funding: Research supported by the HL-LHC project. In the extremely unlikely event of a non-working beam dumping system in the LHC, the 360 MJ of stored beam energy can be dissipated in the collimation system as a last mitigation measure. In such a situation, it is important to reduce the stored beam energy both quickly and at the same time as smoothly as possible in order to limit the risk of trips of critical systems, to avoid quenches of superconducting magnets (which would lead to changes of the beam trajectory and damage to the accelerator) and ultimately damage to the collimators themselves. Detailed steps and parameters have been developed and validated during two dedicated experiments with beam in the LHC. This paper summarizes the key aspects in view of the preparation of such a procedure for operational use, which will allow for the safe disposal of the full LHC beam by the operation crews. |
||
| DOI • | reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2018-MOPMF060 | |
| Export • | reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml) | |