IHEP, Beijing, People’s Republic of China
Superconducting cavities with low RF frequencies and heavy damping of higher order modes (HOM) are desired for the main accelerator of High Energy Photon Source (HEPS), a 6 GeV synchrotron light source promising ultralow emittance currently under construction in Beijing. A compact 166.6 MHz superconducting cavity was proposed adopting a quarter-wave β=1 geometry. Based on the successful development of a proof-of-principle cavity, a HOM-damped 166.6 MHz compact superconducting cavity was subsequently designed. Ferrite damper was installed on the beam pipe to reduce HOM impedance below stringent threshold of coupled-bunch instabilities. Being compact, RF field heating on the cavity vacuum seal was carefully examined against quenching the NbTi flange. The cavity was later dressed with helium vessel and the tuning mechanism was also realized. Excellent RF and mechanical properties were eventually achieved. Finally, the two-cavity string was designed to ensure smooth transitions among components and proper shielding of synchrotron light. This paper presents a complete design of a fully dressed HOM-damped low-frequency β=1 superconducting cavity for HEPS.
IHEP, Beijing, People’s Republic of China
650 MHz 2-cell superconducting cavities are proposed for the main ring of the Circular Electron Positron Collider (CEPC). The design, fabrication, surface treatment (buffered chemical polishing) and vertical tests of the cavities with HOM couplers were conducted. The performance of the cavity at 2 K is not affected by the HOM coupler. The maximum intrinsic quality factor of the cavity with the HOM coupler reached 3.1·1010 at 20 MV/m. The vertical test results showed that the fundamental mode external quality factor of all HOM couplers is an order of magnitude larger than quality factor of the cavity. The HOM damping results for the 650 MHz 2-cell cavity were also measured at cryogenic temperature and compared with the simulated and measured results at room temperature. Two 650 MHz 2-cell cavities jacketed have been integrated into a test cryomodule for CEPC. Another 650 MHz 2-cell cavity reached 6·1010 at 22 MV/m after nitrogen infusion. In addition, two 650 MHz 1-cell cavities reached 2.7·1010 at 35 MV/m (fine grain) and 3.6·1010 at 32 MV/m (large grain) after electro-polishing, respectively. In future, electro-polishing will be applied to 650 MHz 2-cell cavity soon.
