SRF2021 - List of Authors (Iwashita, Y.)

Paper	Title	Page
MOPFDV002	High Density Mapping Sytems for SRF Cavities	323
	Y. Fuwa JAEA/J-PARC, Tokai-mura, Japan R.L. Geng JLab, Newport News, Virginia, USA H. Hayano KEK, Ibaraki, Japan Y. Iwashita, Y. Kuriyama Kyoto University, Research Reactor Institute, Osaka, Japan H. Tongu Kyoto ICR, Uji, Kyoto, Japan
	High density mapping systems for superconducting cavities are prepared. They include sX-map, XT-map and B-map. Each strip of the sX-map system has 32 X-ray sensors approximately 10 mm apart, which can be installed under the stiffener rings to show uniform higher sensitivities. This is suitable to get X-ray distribution around iris areas. The XT-map system enables temperature distribution mapping of cavity cells with high spatial resolution at approximately 10 mm intervals in both azimuth and latitude. It also gives X-ray distribution on cells, as well. Magnetic field distributions can be obtained by B-map system using AMR sensors. Since all these systems are based on the technology of multiplexing at cryogenic side, less number of wires can carry the huge number of signals. The systems are described.
DOI •	reference for this paper ※ doi:10.18429/JACoW-SRF2021-MOPFDV002
About •	Received ※ 02 July 2021 — Revised ※ 19 December 2021 — Accepted ※ 22 January 2022 — Issue date ※ 02 May 2022
Cite •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPFDV008	Instrumentation R&D for the Studies of SRF Thin-Film Structures at KEK and Kyoto University	421
	Y. Fuwa JAEA/J-PARC, Tokai-mura, Japan H. Hayano, H. Ito, R. Katayama, T. Kubo, T. Saeki KEK, Ibaraki, Japan Y. Iwashita, Y. Kuriyama Kyoto University, Research Reactor Institute, Osaka, Japan H. Tongu Kyoto ICR, Uji, Kyoto, Japan
	We have been developing SRF instrumentations by which the effective lower critical magnetic field H_c1,eff of superconducting-material sample is evaluated through the method of the third-order harmonic voltage measurement mainly for the studies of new SRF thin-film structures. Recently, the quad coil system, which enables us to measure four samples simultaneously in a single batch of an experiment, has been developed. In order to study the creation of thin-film structures inside the SRF cavity, we developed 3-GHz-shaped coupon cavities and an XT-map system for the performance tests of 3 GHz cavities. This article reports the details of these works.
DOI •	reference for this paper ※ doi:10.18429/JACoW-SRF2021-TUPFDV008
About •	Received ※ 01 July 2021 — Revised ※ 19 December 2021 — Accepted ※ 02 April 2022 — Issue date ※ 02 May 2022
Cite •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

High Density Mapping Sytems for SRF Cavities

323

Y. Fuwa
JAEA/J-PARC, Tokai-mura, Japan
R.L. Geng
JLab, Newport News, Virginia, USA
H. Hayano
KEK, Ibaraki, Japan
Y. Iwashita, Y. Kuriyama
Kyoto University, Research Reactor Institute, Osaka, Japan
H. Tongu
Kyoto ICR, Uji, Kyoto, Japan

High density mapping systems for superconducting cavities are prepared. They include sX-map, XT-map and B-map. Each strip of the sX-map system has 32 X-ray sensors approximately 10 mm apart, which can be installed under the stiffener rings to show uniform higher sensitivities. This is suitable to get X-ray distribution around iris areas. The XT-map system enables temperature distribution mapping of cavity cells with high spatial resolution at approximately 10 mm intervals in both azimuth and latitude. It also gives X-ray distribution on cells, as well. Magnetic field distributions can be obtained by B-map system using AMR sensors. Since all these systems are based on the technology of multiplexing at cryogenic side, less number of wires can carry the huge number of signals. The systems are described.

DOI •

reference for this paper ※ doi:10.18429/JACoW-SRF2021-MOPFDV002

About •

Received ※ 02 July 2021 — Revised ※ 19 December 2021 — Accepted ※ 22 January 2022 — Issue date ※ 02 May 2022

Cite •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPFDV008

Instrumentation R&D for the Studies of SRF Thin-Film Structures at KEK and Kyoto University

421

Y. Fuwa
JAEA/J-PARC, Tokai-mura, Japan
H. Hayano, H. Ito, R. Katayama, T. Kubo, T. Saeki
KEK, Ibaraki, Japan
Y. Iwashita, Y. Kuriyama
Kyoto University, Research Reactor Institute, Osaka, Japan
H. Tongu
Kyoto ICR, Uji, Kyoto, Japan

We have been developing SRF instrumentations by which the effective lower critical magnetic field H_c1,eff of superconducting-material sample is evaluated through the method of the third-order harmonic voltage measurement mainly for the studies of new SRF thin-film structures. Recently, the quad coil system, which enables us to measure four samples simultaneously in a single batch of an experiment, has been developed. In order to study the creation of thin-film structures inside the SRF cavity, we developed 3-GHz-shaped coupon cavities and an XT-map system for the performance tests of 3 GHz cavities. This article reports the details of these works.

DOI •

reference for this paper ※ doi:10.18429/JACoW-SRF2021-TUPFDV008

About •

Received ※ 01 July 2021 — Revised ※ 19 December 2021 — Accepted ※ 02 April 2022 — Issue date ※ 02 May 2022

Cite •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)