SRF2021 - List of Authors (Geng, R.L.)

Paper	Title	Page
MOPFDV002	High Density Mapping Sytems for SRF Cavities	323
	Y. Fuwa JAEA/J-PARC, Tokai-mura, Japan R.L. Geng JLab, Newport News, Virginia, USA H. Hayano KEK, Ibaraki, Japan Y. Iwashita, Y. Kuriyama Kyoto University, Research Reactor Institute, Osaka, Japan H. Tongu Kyoto ICR, Uji, Kyoto, Japan
	High density mapping systems for superconducting cavities are prepared. They include sX-map, XT-map and B-map. Each strip of the sX-map system has 32 X-ray sensors approximately 10 mm apart, which can be installed under the stiffener rings to show uniform higher sensitivities. This is suitable to get X-ray distribution around iris areas. The XT-map system enables temperature distribution mapping of cavity cells with high spatial resolution at approximately 10 mm intervals in both azimuth and latitude. It also gives X-ray distribution on cells, as well. Magnetic field distributions can be obtained by B-map system using AMR sensors. Since all these systems are based on the technology of multiplexing at cryogenic side, less number of wires can carry the huge number of signals. The systems are described.
DOI •	reference for this paper ※ doi:10.18429/JACoW-SRF2021-MOPFDV002
About •	Received ※ 02 July 2021 — Revised ※ 19 December 2021 — Accepted ※ 22 January 2022 — Issue date ※ 02 May 2022
Cite •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPFDV008	SRF Levitation and Trapping of Nanoparticles	331
	R.L. Geng ORNL, Oak Ridge, Tennessee, USA P. Dhakal, B.J. Kross, F. Marhauser, J.E. McKisson, J. Musson, H. Wang, A. Weisenberger, W.Z. Xi JLab, Newport News, Virginia, USA
	Funding: This material is based upon work supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences & Office of Nuclear Physics. A proposal has been conceived to levitate and trap mesoscopic particles using radio frequency (RF) fields in a superconducting RF(SRF) cavity. Exploiting the intrinsic characteristics of an SRF cavity, this proposal aims at overcoming a major limit faced by state-of-the-art laser trapping techniques. The goal of the proposal is to establish a foundation to enable observation of quantum phenomena of an isolated mechanical oscillator interacting with microwave fields. An experiment supported by LDRD funding at JLab has started to address R&D issues relevant to these new research directions using existing SRF facilities at JLab. The success of this experiment would establish its groundbreaking relevance to quantum information science and technology, which may lead to applications in precision force measurement sensors, quantum memories, and alternative quantum computing implementations with promises for superior coherence characteristics and scalability well beyond the start-of-the-art. In this contribution, we will introduce the proposal and basic consideration of the experiment.
	Poster MOPFDV008 [0.599 MB]
DOI •	reference for this paper ※ doi:10.18429/JACoW-SRF2021-MOPFDV008
About •	Received ※ 10 June 2021 — Accepted ※ 30 September 2021 — Issue date ※ 02 May 2022
Cite •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

High Density Mapping Sytems for SRF Cavities

323

Y. Fuwa
JAEA/J-PARC, Tokai-mura, Japan
R.L. Geng
JLab, Newport News, Virginia, USA
H. Hayano
KEK, Ibaraki, Japan
Y. Iwashita, Y. Kuriyama
Kyoto University, Research Reactor Institute, Osaka, Japan
H. Tongu
Kyoto ICR, Uji, Kyoto, Japan

High density mapping systems for superconducting cavities are prepared. They include sX-map, XT-map and B-map. Each strip of the sX-map system has 32 X-ray sensors approximately 10 mm apart, which can be installed under the stiffener rings to show uniform higher sensitivities. This is suitable to get X-ray distribution around iris areas. The XT-map system enables temperature distribution mapping of cavity cells with high spatial resolution at approximately 10 mm intervals in both azimuth and latitude. It also gives X-ray distribution on cells, as well. Magnetic field distributions can be obtained by B-map system using AMR sensors. Since all these systems are based on the technology of multiplexing at cryogenic side, less number of wires can carry the huge number of signals. The systems are described.

DOI •

reference for this paper ※ doi:10.18429/JACoW-SRF2021-MOPFDV002

About •

Received ※ 02 July 2021 — Revised ※ 19 December 2021 — Accepted ※ 22 January 2022 — Issue date ※ 02 May 2022

Cite •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

MOPFDV008

SRF Levitation and Trapping of Nanoparticles

331

R.L. Geng
ORNL, Oak Ridge, Tennessee, USA
P. Dhakal, B.J. Kross, F. Marhauser, J.E. McKisson, J. Musson, H. Wang, A. Weisenberger, W.Z. Xi
JLab, Newport News, Virginia, USA

Funding: This material is based upon work supported by the U.S. Department of Energy, Office of Science, Office of Basic Energy Sciences & Office of Nuclear Physics.
A proposal has been conceived to levitate and trap mesoscopic particles using radio frequency (RF) fields in a superconducting RF(SRF) cavity. Exploiting the intrinsic characteristics of an SRF cavity, this proposal aims at overcoming a major limit faced by state-of-the-art laser trapping techniques. The goal of the proposal is to establish a foundation to enable observation of quantum phenomena of an isolated mechanical oscillator interacting with microwave fields. An experiment supported by LDRD funding at JLab has started to address R&D issues relevant to these new research directions using existing SRF facilities at JLab. The success of this experiment would establish its groundbreaking relevance to quantum information science and technology, which may lead to applications in precision force measurement sensors, quantum memories, and alternative quantum computing implementations with promises for superior coherence characteristics and scalability well beyond the start-of-the-art. In this contribution, we will introduce the proposal and basic consideration of the experiment.

Poster MOPFDV008 [0.599 MB]

DOI •

reference for this paper ※ doi:10.18429/JACoW-SRF2021-MOPFDV008

About •

Received ※ 10 June 2021 — Accepted ※ 30 September 2021 — Issue date ※ 02 May 2022

Cite •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)