PAC07 - List of Authors (Tenenbaum, P.)

A B C D E F G H I J K L M N O P Q R S T U V W X Y Z

Tenenbaum, P.

Paper	Title	Page
WEOAAB02	The Optimized Bunch Compressor for the International Linear Collider	1958
	S. Seletskiy, P. Tenenbaum SLAC, Menlo Park, California
	The International Linear Collider (ILC) utilizes a two stage Bunch Compressor (BC) that compresses the RMS bunch length from 9 mm to 200 to 300 micrometers before sending the electron beam to the Main Linac. This paper reports on the new design of the optimized BC wiggler. It was reduced in length by more than 30 %. The introduction of nonzero dispersion slope in the BC wigglers enabled them to generate the required compression while having a small SR emittance growth, a tunability range of over a factor of 2 in each wiggler, and less than 3 % RMS energy spread throughout the entire system.
	Slides
THPMS013	Comparison of Tracking Codes for the International Linear Collider	3020
	J. C. Smith CLASSE, Ithaca P. Eliasson Uppsala University, Uppsala K. Kubo KEK, Ibaraki A. Latina, D. Schulte CERN, Geneva P. Lebrun, K. Ranjan Fermilab, Batavia, Illinois F. Poirier, N. J. Walker DESY, Hamburg P. Tenenbaum SLAC, Menlo Park, California
	Funding: Supported by the US Department of Energy, the US National Science Foundation and the Commission of the European Communities under the 6th Framework Programme "Structuring the European Research Area". In an effort to compare beam dynamics and create a ‘‘benchmark'' for Dispersion Free Steering (DFS) a comparison was made between different International Linear Collider (ILC) simulation programs while performing DFS. This study consisted of three parts. First, a simple betatron oscillation was tracked through each code. Secondly, a set of component misalignments and corrector settings generated from one program was read into the other to confirm similar emittance dilution. Thirdly, given the same set of component misalignments DFS was performed independently in each program and the resulting emittance dilution was compared. Performance was found to agree exceptionally well in all three studies.
WEOCAB01	Design of the Beam Delivery System for the International Linear Collider	1985
	A. Seryi, J. A. Amann, R. Arnold, F. Asiri, K. L.F. Bane, P. Bellomo, E. Doyle, A. F. Fasso, L. Keller, J. Kim, K. Ko, Z. Li, T. W. Markiewicz, T. V.M. Maruyama, K. C. Moffeit, S. Molloy, Y. Nosochkov, N. Phinney, T. O. Raubenheimer, S. Seletskiy, S. Smith, C. M. Spencer, P. Tenenbaum, D. R. Walz, G. R. White, M. Woodley, M. Woods, L. Xiao SLAC, Menlo Park, California I. V. Agapov, G. A. Blair, S. T. Boogert, J. Carter Royal Holloway, University of London, Surrey M. Alabau, P. Bambade, J. Brossard, O. Dadoun LAL, Orsay M. Anerella, A. K. Jain, A. Marone, B. Parker BNL, Upton, Long Island, New York D. A.-K. Angal-Kalinin, C. D. Beard, J.-L. Fernandez-Hernando, P. Goudket, F. Jackson, J. K. Jones, A. Kalinin, P. A. McIntosh STFC/DL/ASTeC, Daresbury, Warrington, Cheshire R. Appleby UMAN, Manchester J. L. Baldy, D. Schulte CERN, Geneva L. Bellantoni, A. I. Drozhdin, V. S. Kashikhin, V. Kuchler, T. Lackowski, N. V. Mokhov, N. Nakao, T. Peterson, M. C. Ross, S. I. Striganov, J. C. Tompkins, M. Wendt, X. Yang Fermilab, Batavia, Illinois K. Buesser DESY, Hamburg P. Burrows, G. B. Christian, C. I. Clarke, A. F. Hartin OXFORDphysics, Oxford, Oxon G. Burt, A. C. Dexter Cockcroft Institute, Warrington, Cheshire J. Carwardine, C. W. Saunders ANL, Argonne, Illinois B. Constance, H. Dabiri Khah, C. Perry, C. Swinson JAI, Oxford O. Delferriere, O. Napoly, J. Payet, D. Uriot CEA, Gif-sur-Yvette C. J. Densham, R. J.S. Greenhalgh STFC/RAL, Chilton, Didcot, Oxon A. Enomoto, S. Kuroda, T. Okugi, T. Sanami, Y. Suetsugu, T. Tauchi KEK, Ibaraki A. Ferrari UU/ISV, Uppsala J. Gronberg LLNL, Livermore, California Y. Iwashita Kyoto ICR, Uji, Kyoto W. Lohmann DESY Zeuthen, Zeuthen L. Ma STFC/DL, Daresbury, Warrington, Cheshire T. M. Mattison UBC, Vancouver, B. C. T. S. Sanuki University of Tokyo, Tokyo V. I. Telnov BINP SB RAS, Novosibirsk E. T. Torrence University of Oregon, Eugene, Oregon D. Warner Colorado University at Boulder, Boulder, Colorado N. K. Watson Birmingham University, Birmingham H. Y. Yamamoto Tohoku University, Sendai
	The beam delivery system for the linear collider focuses beams to nanometer sizes at the interaction point, collimates the beam halo to provide acceptable background in the detector and has a provision for state-of-the art beam instrumentation in order to reach the physics goals. The beam delivery system of the International Linear Collider has undergone several configuration changes recently. This paper describes the design details and status of the baseline configuration considered for the reference design.
	Slides
THPMS056	Emittance Preservation in the International Linear Collider Ring to Main Linac Transfer Line	3118
	P. Tenenbaum SLAC, Menlo Park, California K. Kubo KEK, Ibaraki A. Latina CERN, Geneva J. C. Smith CLASSE, Ithaca
	Funding: Work supported by the US Department of Energy, contract DE-AC02-76SF00515. The very small vertical beam emittance in the International Linear Collider (ILC) can be degraded by dispersion, xy coupling, transverse wakefields, and time-varying transverse fields introduced by elements with misalignments, strength errors, xy rotation errors, or yz rotation errors in the Ring to Main Linac (RTML) transfer line. We present a plan for emittance preservation in this beamline which uses local, quasi-local, and global correction schemes. Results of simulations of the emittance preservation algorithm are also presented and discussed.