A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Takasaki, E.

Paper Title Page
TUPAN058 High Power Conditioning of the DTL for J-PARC 1517
 
  • T. Ito, H. Asano, T. Morishita
    JAEA/J-PARC, Tokai-Mura, Naka-Gun, Ibaraki-Ken
  • H. Ao
    JAEA/LINAC, Ibaraki-ken
  • T. Kato, F. Naito, E. Takasaki, H. Tanaka
    KEK, Ibaraki
 
  For the J-PARC, DTL (Drift Tube Linac) is used to accelerate an H- ion beam from 3MeV to 50MeV. The DTL consists of 3 tanks and the all tanks were installed in the accelerator tunnel for J-PARC. After the installation, the high power conditioning has been started in Oct. 2006. The required rf power levels for beam acceleration are about 1.08MW, 1.2MW and 1.03MW (the pulse length is 600μsec and the pulse repetition is 25Hz) for the 1st, 2nd and 3rd tanks, respectively. As a result of the conditioning, we have been achieved that the rf power levels are about 1.3MW, 1.45MW and 1.23MW of 1.2 times required power levels (the pulse length is 650μsec and the pulse repetition is 25Hz). In this paper, the results of the high power conditioning of the DTL tanks are described.  
TUPAN060 The DTL/SDTL Alignment of the J-PARC Linac 1523
 
  • T. Morishita, H. Asano, M. Ikegami, T. Ito
    JAEA/J-PARC, Tokai-Mura, Naka-Gun, Ibaraki-Ken
  • K. Hasegawa
    JAEA, Ibaraki-ken
  • F. Naito, E. Takasaki, H. Tanaka, K. Yoshino
    KEK, Ibaraki
  • A. Ueno
    JAEA/LINAC, Ibaraki-ken
 
  J-PARC linear accelerator components have been installed and the beam commissioning has been started in Nov. 2006. The length of the linear section is about 300 m which consists of the ion source, the radio frequency quadropole linac(RFQ), the drift tube linac(DTL), separated type DTL(SDTL), and the beam transport line. Precise alignment of the accelerator components is essential for high quality beam acceleration. The required alignment error in the J-PARC linac is 0.1mm in transverse direction. In the DTL/SDTL section, the fine alignment was carried out by using an optical alignment telescope along with the cavity installation. The relay targets were placed at short intervals for smooth connection between neighboring components. After the installation, the DTL/SDTL positions were confirmed by measuring the reference base by using a laser tracker. In this paper, the alignment procedure for the DTL/SDTL section and the results by the laser tracker measurements are described.