• C. K. Sinclair, I. V. Bazarov, B. M. Dunham, Y. Li, X. G. Liu, D. G. Ouzounov
  Cornell University, Department of Physics, Ithaca, New York
• F. E. Hannon
  Cockcroft Institute, Lancaster University, Lancaster
• T. Miyajima
  KEK, Ibaraki

Recent computational optimizations have demonstrated that it should be possible to construct electron injectors based on photoemission cathodes in very high voltage DC electron guns in which the beam emittance is dominated by the thermal emittance from the cathode. Negative electron affinity photocathodes have been shown to have a naturally low thermal emittance. However, the thermal emittance depends on the illuminating wavelength; the degree of negative affinity; and the band structure of the photocathode material. As part of the development of a high brightness, high average current photoemission electron gun for the injector of an ERL light source, we have measured the thermal emittance from negative affinity GaAs and GaAsP photocathodes. The measurements were made by measuring the electron beam spot size downstream of a counter-wound solenoid lens as a function of the lens strength. Electron beam spot sizes were measured by two techniques - a 20 micron wire scanner, and a CVD diamond screen. Both Gaussian and 'tophat' spatial profiles were used, and measurements were made at several wavelengths. Results will be presented for both cathode types.

• C. K. Sinclair, I. V. Bazarov, B. M. Dunham, Y. Li, X. G. Liu
  Cornell University, Department of Physics, Ithaca, New York
• K. W. Smolenski
  CLASSE, Ithaca

We have constructed a very high voltage photoemission electron gun as the electron source of a high brightness, high average current injector for an energy recovery linac (ERL) synchrotron radiation light source. The source is designed to deliver 100 mA average current in a CW 1300 MHz pulse train (77 pC/bunch). The cathode voltage may be as high as 750 kV. Negative electron affinity photocathodes are employed to obtain small thermal emittances. The electrode structure is assembled without touching any electrode surface. A load-lock system allows cleaning and activation of cathode samples prior to installation in the electron gun. Cathodes are cleaned by heating and exposure to atomic hydrogen, and activated with cesium and nitrogen trifluoride. Two cathode electrode sets, of 316LN stainless steel and Ti4V6Al alloy, have been used. The anode is beryllium. The internal surface of the ceramic insulator of the gun has a high resistivity fired coating, providing a path to drain away charge from field emission. Non-evaporable getters provide a very high pumping speed for hydrogen. Operating experience with this gun will be presented.