IUCF, Bloomington, Indiana
The Low Energy Neutron Source (LENS) at Indiana University is producing neutrons by using a 7 MeV proton beam incident on a Beryllium target. The Proton Delivery System is currently being upgraded. A new DTL section will be added to increase proton beam energy from 7 to 13 MeV. A 3 MeV RFQ and 13 MeV DTL will be powered by 1 MW klystrons. The goal of this upgrade is a 13 MeV, 20 mA proton beam with duty factor more than 1%. At this power level it becomes increasingly important to make a proton beam that is uniformly distributed to prevent excessive thermal stress at the surface of the Be target. To achieve this goal two octupole magnets are being implemented in the LENS beam transport line. In this paper we discuss the experimental results of the beam intensity redistribution as well as some features inherent in tuning of the nonlinear beamline and our operational experience.
Jefferson Lab, Newport News, Virginia
IUCF, Bloomington, Indiana
BTG, New York
BNL, Upton, Long Island, New York
ANL, Argonne, Illinois
Experiments on the study of fundamental quark-gluon structure of nucleons require an electron-light ion collider of a center of mass energy from 20 to 65 GeV at luminosity level of 1035 cm-2s-1 with both beams polarized. A CEBAF accelerator based ring-ring collider of 7 GeV electrons/positrons and 150 GeV light ions is envisioned as a possible next step after the 12 GeV CEBAF Upgrade. The developed ring-ring scheme takes advantage of the existing polarized continuous electron beam and SRF linac, the green-field design of the collider rings and the ion accelerator complex with electron cooling. We report results of our design studies of the ring-ring version of an electron-light ion collider of the required luminosity.
LANL, Los Alamos, New Mexico
IUCF, Bloomington, Indiana
This paper describes the Klystron RF systems for the Indiana University Low Energy Neutron Source (LENS) accelerator 425 MHz Radio Frequency Quadrupole (RFQ) and Drift Tube Linac (DTL) systems. Of interest in the power conditioning system is the design of the totem-pole grid-catch modulator for the mod-anode klystrons. This topology provides a fast rise and fall and closed loop regulation for the klystron mod-anode to cathode voltage, which minimizes RF amplitude and phase droop while maximizing efficiency. Another advantage is that short pulse high rep-rate operation is viable within the average power capabilities of the klystron. The 425 MHz, 1.25 MW klystron amplifier chain will also be detailed. Of final interest, is the digital low level RF system. This provides vector control of the cavity field using direct conversion, non-I/Q sampling architecture, at a sampling rate of 132 MHz with a 12-bit ADC. Four input and two output channels are integrated into a 6U VME module, with all DSP functions performed in Xilinx Spartan-3 field-programmable gate arrays. The design and implementation of these systems, coupled with LENS operational results, will be presented.
IUCF, Bloomington, Indiana
A Low Energy Neutron Source at Indiana University provides cold neutrons for material research and neutron physics as well as neutrons in the MeV energy range for the neutron radiation effects studies. Neutrons are being produced by a 7 MeV proton beam incident on a Beryllium target. Presently, the Proton Delivery System has been routinely running at 7 MeV, 8 mA and with up to 0.5% duty factor. The RF system of the accelerator is currently being upgraded by replacing 350 kW 425 MHz 12 tube amplifiers with two Litton 5773 klystron RF tubes capable of running at 425 MHz and 1 MW. A new DTL section will be added to increase proton beam energy from 7 to 13 MeV. A 3 MeV RFQ and 13 MeV DTL will be powered by the klystrons. The expected output is 20 mA and 13 MeV of proton current at more than 1% duty factor. Other upgrades include construction of the 2nd beamline, which copies the 1st line, and a new target station for the production of cold neutrons. In this contribution we discuss the results of the commissioning of the new DTL accelerator, new RF system and 2nd beamline. The future plans will also be outlined.