A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z    

Shapiro, M.A.

Paper Title Page
TPAE023 3D Metallic Lattices for Accelerator Applications 1838
  • M.A. Shapiro, J.R. Sirigiri, R.J. Temkin
    MIT/PSFC, Cambridge, Massachusetts
  • G. Shvets
    The University of Texas at Austin, Austin, Texas
  Funding: DOE-HEP

We present the results of research on 3D metallic lattices operating at microwave frequencies for application in (1) accelerator structures with higher order mode suppression, (2) Smith-Purcell radiation beam diagnostics, and (3) polaritonic materials for laser acceleration. Electromagnetic waves in a 3D simple cubic lattice formed by metal wires are calculated using HFSS. The bulk modes in the lattice are determined using single cell calculations with different phase advances in all three directions. The Brillouin diagram for the bulk modes is presented and indicates the absence of band gaps in simple lattices except the band below the cutoff. Lattices with thin wires as well as with thick wires have been analyzed. The Brillouin diagram also indicates the presence of low frequency 3D plasmon mode as well as the two degenerate photon modes analogous to those in a 2D lattice. Surface modes for a semi-infinite cubic lattice are modeled as a stack of cells with different phase advances in the two directions along the surface. The surface modes are found for both the thin and thick wire lattices in the band below the cutoff. They demonstrate that the lattice acts as a negative dielectric constant material.

TOPA009 Photonic Band Gap Accelerator Demonstration at Ku-Band. 656
  • E.I. Smirnova, L.M. Earley, R.L. Edwards
    LANL, Los Alamos, New Mexico
  • A.S. Kesar, I. Mastovsky, M.A. Shapiro, R.J. Temkin
    MIT/PSFC, Cambridge, Massachusetts
  Funding: The research is supported by DOE High Energy Physics, Contract No. DE-FG02-91ER40648.

We report progress on the design and cold test of a metal Ku-band PBG accelerator structure. The 17.140 GHz 6-cell PBG accelerator structure with reduced long-range wakefields was designed for the experiment. The copper structure was electroformed and cold-tested. Tuning was performed through chemical etching of the rods. Final cold test measurements were found to be in very good agreement with the design. The structure will be installed on the beam line at the accelerator laboratory at Massachusetts Institute of Technology and will be powered with 3 MW of peak power from the Haimson 17.14 GHz klystron. Results of the design, fabrication, cold test and hot test on the Haimson accelerator will be presented.