NAPAC2016 - List of Authors (Cullerton, E.)

Paper	Title	Page
TUPOA18	Low Level RF Control for the PIP-II Injector Test RFQ	323
	J.P. Edelen, B.E. Chase, E. Cullerton, J. Einstein, P. Varghese Fermilab, Batavia, Illinois, USA
	The PIP-II injector test radio frequency quadrupole (RFQ) arrived at Fermilab in the fall of 2015. The RFQ is a 162.5MHz H⁻ accelerator with a nominal drive power of 100kW, which produces a bunched H⁻ beam at 2.1MeV. In this paper we discuss commissioning, operational performance, and improvements to the low level RF (LLRF) control system for the RFQ. We begin by describing the general system configuration and initial simulation results. We will then highlight temperature related issues in the high power RF system, which necessitate active control over the phase balance of the two amplifiers. Finally we demonstrate performance of the RF feedback and feed-forward compensation needed to meet specification during a 20-microsecond beam pulse.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-TUPOA18
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPOA19	50-MeV Run of the IOTA/FAST Electron Accelerator	326
	D.R. Edstrom, C.M. Baffes, C.I. Briegel, D.R. Broemmelsiek, K. Carlson, B.E. Chase, D.J. Crawford, E. Cullerton, J.S. Diamond, N. Eddy, B.J. Fellenz, E.R. Harms, M.J. Kucera, J.R. Leibfritz, A.H. Lumpkin, D.J. Nicklaus, E. Prebys, P.S. Prieto, J. Reid, A.L. Romanov, J. Ruan, J.K. Santucci, T. Sen, V.D. Shiltsev, Y.-M. Shin, G. Stancari, J.C.T. Thangaraj, R.M. Thurman-Keup, A. Valishev, A. Warner, S.J. Wesseln Fermilab, Batavia, Illinois, USA A.T. Green Northern Illinois Univerity, DeKalb, Illinois, USA A. Halavanau, D. Mihalcea, P. Piot Northern Illinois University, DeKalb, Illinois, USA J. Hyun Sokendai, Ibaraki, Japan P. Kobak BYU-I, Rexburg, USA W.D. Rush KU, Lawrence, Kansas, USA
	Funding: Supported by the DOE contract No.DEAC02-07CH11359 to the Fermi Research Alliance LLC. The low-energy section of the photoinjector-based electron linear accelerator at the Fermilab Accelerator Science & Technology (FAST) facility was recently commissioned to an energy of 50 MeV. This linear accelerator relies primarily upon pulsed SRF acceleration and an optional bunch compressor to produce a stable beam within a large operational regime in terms of bunch charge, total average charge, bunch length, and beam energy. Various instrumentation was used to characterize fundamental properties of the electron beam including the intensity, stability, emittance, and bunch length. While much of this instrumentation was commissioned in a 20 MeV running period prior, some (including a new Martin-Puplett interferometer) was in development or pending installation at that time. All instrumentation has since been recommissioned over the wide operational range of beam energies up to 50 MeV, intensities up to 4 nC/pulse, and bunch structures from ~1 ps to more than 50 ps in length.
	Poster TUPOA19 [4.636 MB]
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-TUPOA19
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPOA52	Updates to the Low-Level RF Architecture for Fermilab	394
	J. Einstein, B.E. Chase, E. Cullerton, P. Varghese Fermilab, Batavia, Illinois, USA S. Biedron, S.V. Milton CSU, Fort Collins, Colorado, USA D. Sharma RRCAT, Indore (M.P.), India
	Fermilab has teamed with Colorado State University on several projects in LLRF controls and architecture. These projects include new LLRF hardware, updated controls techniques, and new system architectures. Here we present a summary of our work to date.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-TUPOA52
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

FRA2IO02	High Precision RF Control for the LCLS-II	1292
	G. Huang, K. Campbell, L.R. Doolittle, J.A. Jones, C. Serrano, V.K. Vytla LBNL, Berkeley, California, USA S. Babel, M. Boyes, G.W. Brown, D. Cha, B. Hong, A. Ratti, C.H. Rivetta SLAC, Menlo Park, California, USA R. Bachimanchi, C. Hovater, D.J. Seidman JLab, Newport News, Virginia, USA B.E. Chase, E. Cullerton, Q. Du, J. Einstein, D.W. Klepec Fermilab, Batavia, Illinois, USA
	Funding: Work supported by the LCLS-II Project and the U.S. Department of Energy, Contract DE-AC02-76SF00515 The LCLS-II is a CW superconducting linac under construction to drive an X-ray FEL. The energy and timing stability requirements of the FEL drive the need for very high precision RF control. This paper summarize the design considerations and early demonstration of the performance of the components and system we developed.
DOI •	reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-FRA2IO02
Export •	reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

Paper

Title

Page

Low Level RF Control for the PIP-II Injector Test RFQ

323

J.P. Edelen, B.E. Chase, E. Cullerton, J. Einstein, P. Varghese
Fermilab, Batavia, Illinois, USA

The PIP-II injector test radio frequency quadrupole (RFQ) arrived at Fermilab in the fall of 2015. The RFQ is a 162.5MHz H⁻ accelerator with a nominal drive power of 100kW, which produces a bunched H⁻ beam at 2.1MeV. In this paper we discuss commissioning, operational performance, and improvements to the low level RF (LLRF) control system for the RFQ. We begin by describing the general system configuration and initial simulation results. We will then highlight temperature related issues in the high power RF system, which necessitate active control over the phase balance of the two amplifiers. Finally we demonstrate performance of the RF feedback and feed-forward compensation needed to meet specification during a 20-microsecond beam pulse.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-TUPOA18

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPOA19

50-MeV Run of the IOTA/FAST Electron Accelerator

326

D.R. Edstrom, C.M. Baffes, C.I. Briegel, D.R. Broemmelsiek, K. Carlson, B.E. Chase, D.J. Crawford, E. Cullerton, J.S. Diamond, N. Eddy, B.J. Fellenz, E.R. Harms, M.J. Kucera, J.R. Leibfritz, A.H. Lumpkin, D.J. Nicklaus, E. Prebys, P.S. Prieto, J. Reid, A.L. Romanov, J. Ruan, J.K. Santucci, T. Sen, V.D. Shiltsev, Y.-M. Shin, G. Stancari, J.C.T. Thangaraj, R.M. Thurman-Keup, A. Valishev, A. Warner, S.J. Wesseln
Fermilab, Batavia, Illinois, USA
A.T. Green
Northern Illinois Univerity, DeKalb, Illinois, USA
A. Halavanau, D. Mihalcea, P. Piot
Northern Illinois University, DeKalb, Illinois, USA
J. Hyun
Sokendai, Ibaraki, Japan
P. Kobak
BYU-I, Rexburg, USA
W.D. Rush
KU, Lawrence, Kansas, USA

Funding: Supported by the DOE contract No.DEAC02-07CH11359 to the Fermi Research Alliance LLC.
The low-energy section of the photoinjector-based electron linear accelerator at the Fermilab Accelerator Science & Technology (FAST) facility was recently commissioned to an energy of 50 MeV. This linear accelerator relies primarily upon pulsed SRF acceleration and an optional bunch compressor to produce a stable beam within a large operational regime in terms of bunch charge, total average charge, bunch length, and beam energy. Various instrumentation was used to characterize fundamental properties of the electron beam including the intensity, stability, emittance, and bunch length. While much of this instrumentation was commissioned in a 20 MeV running period prior, some (including a new Martin-Puplett interferometer) was in development or pending installation at that time. All instrumentation has since been recommissioned over the wide operational range of beam energies up to 50 MeV, intensities up to 4 nC/pulse, and bunch structures from ~1 ps to more than 50 ps in length.

Poster TUPOA19 [4.636 MB]

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-TUPOA19

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

TUPOA52

Updates to the Low-Level RF Architecture for Fermilab

394

J. Einstein, B.E. Chase, E. Cullerton, P. Varghese
Fermilab, Batavia, Illinois, USA
S. Biedron, S.V. Milton
CSU, Fort Collins, Colorado, USA
D. Sharma
RRCAT, Indore (M.P.), India

Fermilab has teamed with Colorado State University on several projects in LLRF controls and architecture. These projects include new LLRF hardware, updated controls techniques, and new system architectures. Here we present a summary of our work to date.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-TUPOA52

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)

FRA2IO02

High Precision RF Control for the LCLS-II

1292

G. Huang, K. Campbell, L.R. Doolittle, J.A. Jones, C. Serrano, V.K. Vytla
LBNL, Berkeley, California, USA
S. Babel, M. Boyes, G.W. Brown, D. Cha, B. Hong, A. Ratti, C.H. Rivetta
SLAC, Menlo Park, California, USA
R. Bachimanchi, C. Hovater, D.J. Seidman
JLab, Newport News, Virginia, USA
B.E. Chase, E. Cullerton, Q. Du, J. Einstein, D.W. Klepec
Fermilab, Batavia, Illinois, USA

Funding: Work supported by the LCLS-II Project and the U.S. Department of Energy, Contract DE-AC02-76SF00515
The LCLS-II is a CW superconducting linac under construction to drive an X-ray FEL. The energy and timing stability requirements of the FEL drive the need for very high precision RF control. This paper summarize the design considerations and early demonstration of the performance of the components and system we developed.

DOI •

reference for this paper ※ https://doi.org/10.18429/JACoW-NAPAC2016-FRA2IO02

Export •

reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)