LINAC2014 - List of Authors (Shishlo, A.P.)

Paper	Title	Page
MOIOC03	Model and Beam Based Setup Procedures for a High Power Hadron Superconducting Linac	41
	A.P. Shishlo ORNL, Oak Ridge, Tennessee, USA
	This presentation will review methods for experimental determination of optimal operational set points in a multi-cavity superconducting high power hadron linac. A typical tuning process, including establishing correct acceleration profile and RMS bunch size matching, is based on comparison between measured data and the results of simulations from envelope, single and multi-particle models. Presence of significant space charge effects requires simulation and measurement of bunch dynamics in 3 dimensions to ensure low loss beam transport. This is especially difficult in a superconducting linac where use of interceptive diagnostics is usually restricted because of the risk of SRF cavity surface contamination. The procedures discussed here are based on non-interceptive diagnostics such as beam position monitors and laser wires, and conventional diagnostics devices such as wire scanners and bunch shape monitors installed outside the superconducting linac. The longitudinal Twiss analysis based on the BPM signals will be described. The superconducting SNS linac tuning experience will be used to demonstrate problems and their solution for real world linac tune-up procedures.
	Slides MOIOC03 [1.954 MB]

MOPP114	SNS Linac Upgrade Plans for the Second Target Station	320
MOPOL06	use link to see paper's listing under its alternate paper code
	J. Galambos, D.E. Anderson, M.P. Howell, S.-H. Kim, M.A. Plum, A.P. Shishlo ORNL, Oak Ridge, Tennessee, USA M.E. Middendorf ORNL RAD, Oak Ridge, Tennessee, USA
	Funding: ORNL is managed by UT-Battelle, LLC, under contract DE-AC05-00OR22725 for the U.S. Department of Energy. The Second Target Station (STS) upgrade for the Spallation Neutron Source (SNS) proposes the addition of a short pulse, long wavelength neutron scattering station. In order to provide world-class intensity at the additional station, the SNS linac beam power capability is doubled, to 2.8 MW. This will be accommodated by a 30% increase in the beam energy to 1.3 GeV and a 50% increase in beam current. The beam energy increase will be provided by the addition of 7 additional cyro-modules and supporting RF equipment in space provided during the original SNS construction. The beam current increase will be provided by improved ion source and a reduced chopping fraction, and will require increases in the RF and high voltage modulator systems to accommodate the additional beam loading. Initial plans will be presented. The proposed linac upgrade path will be described.

Paper

Title

Page

Model and Beam Based Setup Procedures for a High Power Hadron Superconducting Linac

41

A.P. Shishlo
ORNL, Oak Ridge, Tennessee, USA

This presentation will review methods for experimental determination of optimal operational set points in a multi-cavity superconducting high power hadron linac. A typical tuning process, including establishing correct acceleration profile and RMS bunch size matching, is based on comparison between measured data and the results of simulations from envelope, single and multi-particle models. Presence of significant space charge effects requires simulation and measurement of bunch dynamics in 3 dimensions to ensure low loss beam transport. This is especially difficult in a superconducting linac where use of interceptive diagnostics is usually restricted because of the risk of SRF cavity surface contamination. The procedures discussed here are based on non-interceptive diagnostics such as beam position monitors and laser wires, and conventional diagnostics devices such as wire scanners and bunch shape monitors installed outside the superconducting linac. The longitudinal Twiss analysis based on the BPM signals will be described. The superconducting SNS linac tuning experience will be used to demonstrate problems and their solution for real world linac tune-up procedures.

Slides MOIOC03 [1.954 MB]

MOPP114

SNS Linac Upgrade Plans for the Second Target Station

320

MOPOL06

use link to see paper's listing under its alternate paper code

J. Galambos, D.E. Anderson, M.P. Howell, S.-H. Kim, M.A. Plum, A.P. Shishlo
ORNL, Oak Ridge, Tennessee, USA
M.E. Middendorf
ORNL RAD, Oak Ridge, Tennessee, USA

Funding: ORNL is managed by UT-Battelle, LLC, under contract DE-AC05-00OR22725 for the U.S. Department of Energy.
The Second Target Station (STS) upgrade for the Spallation Neutron Source (SNS) proposes the addition of a short pulse, long wavelength neutron scattering station. In order to provide world-class intensity at the additional station, the SNS linac beam power capability is doubled, to 2.8 MW. This will be accommodated by a 30% increase in the beam energy to 1.3 GeV and a 50% increase in beam current. The beam energy increase will be provided by the addition of 7 additional cyro-modules and supporting RF equipment in space provided during the original SNS construction. The beam current increase will be provided by improved ion source and a reduced chopping fraction, and will require increases in the RF and high voltage modulator systems to accommodate the additional beam loading. Initial plans will be presented. The proposed linac upgrade path will be described.