Paper |
Title |
Page |
MO1A01 |
Operational Experience and Future Goals of the SARAF Linac at SOREQ |
100 |
|
- D. Berkovits, A. Arenshtam, Y. Ben Aliz, Y. Buzaglo, O. Dudovich, Y. Eisen, I. Eliyahu, G. Feinberg, I. Fishman, I. Gavish, I.G. Gertz, A. Grin, S. Halfon, D. Har-Even, Y.F. Haruvy, T. Hirsch, D. Hirschmann, Z. Horvitz, B. Kaizer, D. Kijel, A. Kreisel, G. Lempert, J. Luner, I. Mardor, A. Perry, E. Reinfeld, J. Rodnizki, G. Shimel, A. Shor, I. Silverman, L. Weissman, E. Zemach
Soreq NRC, Yavne, Israel
|
|
|
SARAF-phase 1 at SOREQ, with its single 6 half-wave resonators cryomodule, is the first high current, superconducting low-beta linac in operation and it is presently delivering cw proton beams in the mA range. A phase 2 is foreseen for this linac which will allow acceleration up to 40 MeV of 2 mA cw proton and deuteron beams. The project status, the operational experience and the future goals of SARAF should be described.
|
|
|
Slides MO1A01 [3.276 MB]
|
|
|
TUPB092 |
High Power Amplifier Systems for SARAF Phase II |
675 |
|
- B. Kaizer, I. Fishman, I.G. Gertz
Soreq NRC, Yavne, Israel
|
|
|
Soreq NRC initiated the establishment of SARAF - Soreq Applied Research Accelerator Facility. SARAF is based on a continuous wave (CW), proton/deuteron RF superconducting linear accelerator with variable energy (5–40 MeV) and current (0.04-5 mA). RF power to each cavity is driven by a High Power Solid State Amplifiers. The paper outlines the design concept of the 10 and 15 kW at 176 MHz power amplifiers that were designed, built, and 10 kW successfully tested. 15 kW is now under construction. The amplifiers are combined from basic 5.5 kW compact 19" 7U water cooled drawer.
|
|
|
THPB094 |
Performance of Beam Chopper at SARAF via RF Deflector Before the RFQ |
1038 |
|
- A. Shor, D. Berkovits, I. Fishman, A. Grin, B. Kaizer, L. Weissman
Soreq NRC, Yavne, Israel
|
|
|
We describe performance of a beam chopper at the SARAF accelerator consisting of an HV deflector preceding the RFQ. The deflector and electronics, developed at LNS Catania, was designed to provide slow beam chopping for beam testing and diagnostics where low beam power is necessary. The HV deflector sweeps away the low energy beam onto a water cooled beam catcher, while a fast HV switch momentarily switches off the HV whenever a transmitted beam to the RFQ is desired. We report on measurements with this chopping system, where minimum transmitted beam pulse of 180 ns duration is attained with a rise and fall time of several nano-seconds. We performed beam dynamics simulations of SARAF Phase-I, including the deflector, where the short rise and fall times of the chopped beam is attributed to the tight collimation of the deflected beam provided by the RFQ and the fast Faraday Cup. We also describe beam dynamics simulations which suggest that single RFQ bunch selection can be achieved with the existing chopping system, during zero-crossover for positive-negative deflecting HV waveform.
|
|
|