| Paper |
Title |
Page |
| MOP030 |
An Upgrade to NSCL to Produce Intense Beams of Exotic Nuclei
|
103 |
| |
- R. C. York, M. Doleans, D. Gorelov, T. L. Grimm, W. Hartung, F. Marti, S. O. Schriber, X. Wu, Q. Zhao
NSCL, East Lansing, Michigan
|
|
| |
A substantially less costly alternative to the Rare Isotope Accelerator (RIA) project has been developed at Michigan State University (MSU). By upgrading the existing facility at the National Superconducting Cyclotron Laboratory (NSCL), it will be possible to produce stable beams of heavy ions at energies of greater than 180 MeV/u with beam power in excess of >80 kW. The upgrade will utilize a cyclotron injector and superconducting driver linac at a base frequency of 80.5 MHz. Radioactive ion beams will be produced in a high-power target via particle fragmentation. A charge-stripping foil and multiple-charge-state acceleration will be used for the heavier ions. The 9 MeV/u injector will include an ECR source, a bunching system, and the existing K1200 superconducting cyclotron with axial injection. The superconducting driver linac will largely follow that proposed by MSU for RIA, using cavities already designed, prototyped, and demonstrated for RIA. The existing A1900 Fragmentation Separator and experimental areas will be used, along with a new gas stopper and reacceleration system.
|
|
| TUP085 |
Beam Simulations for the MSU-RIA Driver Linac Using IMPACT Code
|
457 |
| |
- Q. Zhao, M. Doleans, D. Gorelov, F. Marti, X. Wu, R. C. York
NSCL, East Lansing, Michigan
- J. Qiang
LBNL, Berkeley, California
|
|
| |
Previous end-to-end three-dimensional (3D) beam dynamics simulation studies at Michigan State University (MSU) utilizing the LANA code and including experimentally-based ion source beam parameters, alignment and rf errors, and the effect of charge-stripping foils have indicated that the MSU Rare Isotope Accelerator (RIA) driver linac has adequate transverse and longitudinal acceptances to accelerate light and heavy ions to final energies of ≥ 400 MeV/u with beam powers of 100 to 400 kW. Recently, to evaluate beam dynamics performance under various error scenarios with high statistics, the end-to-end 3D beam dynamics simulation studies for the driver linac were performed on the high performance parallel computers at MSU using the parallel code IMPACT that is an element of the advanced beam dynamics simulation tool: RIAPMTQ/IMPACT. The results of these beam dynamics studies will be presented.
|
|
| TUP079 |
RIAPMTQ/IMPACT: Beam-Dynamics Simulation Tool for RIA
|
441 |
| |
- T. P. Wangler, J. A. Billen, R. W. Garnett
LANL, Los Alamos, New Mexico
- V. N. Aseev, B. Mustapha, P. N. Ostroumov
ANL, Argonne, Illinois
- K. R. Crandall
TechSource, Santa Fe, New Mexico
- M. Doleans, D. Gorelov, X. Wu, R. C. York, Q. Zhao
NSCL, East Lansing, Michigan
- J. Qiang, R. D. Ryne
LBNL, Berkeley, California
|
|
| |
We describe a multiple-charge-state simulation-code package for end-to-end computer simulations of the RIA heavy-ion driver linac, extending from the low-energy beam transport after the ECR source to the end of the linac. The work is being performed by a collaboration including LANL, LBNL, ANL, and MSU. The package consists of two codes, the code RIAPMTQ for the linac front end including the LEBT, RFQ, and MEBT, and the code IMPACT for the superconducting linac. This code package has been benchmarked for rms beam properties against previously existing codes at ANL and MSU. The simulation tool will allow high-statistics runs on parallel supercomputing platforms, such as NERSC, as well as runs on desktop PC computers for low-statistics design work. It will address an important near-term need for the RIA project, allowing evaluations of candidate designs with respect to beam-dynamics performance including beam losses, which can be compared with predictions of other existing simulation codes.
|
|