BNL, Upton, New York, USA
ODU, Norfolk, Virginia, USA
SLAC, Menlo Park, California, USA
Brookhaven National Laboratory (BNL), Electron-Ion Collider, Upton, New York, USA
Crab cavity is essential for retrieving the loss in luminosity due to the large crossing angle in the two colliding beam lines of the Electron Ion Collider (EIC). Due to the asymmetric design of the proton beam crab cavity, the fundamental mode consists of contributions from higher order multipoles. These multipole modes may change during fabrication and installation of the cavities, and therefore affect the local dynamic aperture. Thresholds for each order of the multipoles are applied to ensure dynamic aperture requirements at these crab cavities. In this paper, we analyzed the strength of the multipoles due to fabrication and installation accuracies, and set limitations to each procedure to maintain the dynamic aperture requirement.
WEOYGD2
Stony Brook University, Stony Brook, USA
BNL, Upton, New York, USA
SUNY SB, Stony Brook, New York, USA
Coherent electron Cooling (CeC) experiment aims on demonstrating cooling during this RHIC run, which will be concluded in April 2022. In this talk we will present results of the CeC experiment with special focus won the use and the control of the broad-band micro-bunching Plasma Cascade Amplifier with bandwidth of 15 THz. We will also discuss connection of this experiment with the developing the CeC cooler for future Electron Ion Collider.
BNL, Upton, New York, USA
ANL, Lemont, Illinois, USA
The Electron-Ion Collider (EIC), the next-generation nuclear science facility, is under the design at the Brookhaven National Laboratory. The present RHIC rings will be reconfigured as the Hadron Storage Ring (HSR) for the EIC. Design of a stripline injection kicker for the HSR for beams with the rigidity of ∼ 81 T-m poses some technical challenges due to the expected shorter bunch spacing, heating due to higher peak current and the larger number of bunches, and the required higher pulsed voltage. Recently, we updated its mechanical design to optimize the characteristic and beam coupling impedances. In addition, we incorporated the impedance tuning capability by introducing the kicker aperture adjustment mechanism. Finally, we incorporated high voltage FID feedthroughs (FC26) to this kicker. This paper reports the design and optimization updates of the HSR injection kicker including the impedance tuning capability, optimization of both the characteristic and the beam coupling impedances, and finally the incorporation of a high voltage feedthrough design.