Author: Ego, H.
Paper Title Page
TUPAB004 Progress of 7-GeV SuperKEKB Injector Linac Upgrade and Commissioning 1300
 
  • K. Furukawa, M. Akemoto, D.A. Arakawa, Y. Arakida, H. Ego, A. Enomoto, Y. Enomoto, S. Fukuda, Y. Funahashi, T. Higo, H. Honma, N. Iida, M. Ikeda, H. Kaji, K. Kakihara, T. Kamitani, H. Katagiri, M. Kawamura, M. Kurashina, S. Matsumoto, T. Matsumoto, H. Matsushita, S. Michizono, K. Mikawa, T. Miura, F. Miyahara, H. Nakajima, K. Nakao, T. Natsui, M. Nishida, Y. Ogawa, Y. Ohnishi, S. Ohsawa, F. Qiu, I. Satake, D. Satoh, M. Satoh, Y. Seimiya, A. Shirakawa, H. Sugimoto, H. Sugimura, T. Suwada, T. Takatomi, T. Takenaka, M. Tanaka, N. Toge, Y. Yano, K. Yokoyama, M. Yoshida, R. Zhang, X. Zhou
    KEK, Ibaraki, Japan
 
  KEK injector linac has delivered electrons and positrons for particle physics and photon science experiments for more than 30 years. It is being upgraded for the SuperKEKB project, which aims at a 40-fold increase in luminosity over the previous project KEKB, in order to increase our understanding of new physics beyond the standard model of elementary particle physics. SuperKEKB asymmetric electron and positron collider with its extremely high luminosity requires a high current, low emittance and low energy spread injection beam from the injector. Electron beams will be generated by a new type of RF gun, that will provide a much higher beam current to correspond to a large stored beam current and a short lifetime in the ring. The positron source is another major challenge that enhances the positron bunch intensity from 1 to 4 nC by increasing the positron capture efficiency, and the positron beam emittance is reduced from 2000 micron to 20 micron in the vertical plane by introducing a damping ring, followed by the bunch compressor and energy compressor. The recent status of the upgrade and beam commissioning is reported.  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2017-TUPAB004  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)  
 
THPAB117 Development of a New LLRF System Based on MicroTCA.4 for the SPring-8 Storage Ring 3996
 
  • T. Ohshima, H. Ego, N. Hosoda, H. Maesaka
    RIKEN SPring-8 Center, Sayo-cho, Sayo-gun, Hyogo, Japan
  • T. Fukui
    RIKEN SPring-8 Center, Innovative Light Sources Division, Hyogo, Japan
  • M. Ishii
    JASRI/SPring-8, Hyogo-ken, Japan
 
  SPring-8 is a 3rd generation synchrotron radiation facility, which has been operated since 1997. The analog-circuit-based rf modules now in use at the storage ring are obsolete and hard to be maintained. The renewal of them with modern digital ones is underway and the developed LLRF system will be used for the operation of SPring-8-II. We built an amplitude and phase stabilizing system with commercial MicroTCA.4 modules. A motor driver controlled through EtherCAT was newly adapted to the cavity tuner. The system was implemented to the high power rf test stand which consists of a 1 MW klystron, a circulator, and a 508.58 MHz cavity. The rf power was successfully regulated to keep the cavity voltage with an amplitude deviation of less than 0.1% and a phase stability of less than 0.1 degree in rms. We are also developing new MTCA.4 modules: a digitizer AMC having sampling rate of 370 MHz and 16bit resolution, and a signal conditioning RTM. These modules are used for under-sampling rf detection achieving simple composition and more robustness to the ambient parameter changes. We will start installation of the digital system to one of four rf stations in the storage ring in summer 2017.  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2017-THPAB117  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)