Author: Brunetti, L.
Paper Title Page
TUPAB001 Proof of Concept of CLIC Final Focus Quadrupoles Stabilization 1290
 
  • G. Balik, B. Aimard, L. Brunetti
    IN2P3-LAPP, Annecy-le-Vieux, France
  • B. Caron
    SYMME, Annecy-le-Vieux, France
 
  The Compact LInear Collider (CLIC) [1] luminosity requires extremely low beam emittances. Therefore, high beam position stability is needed to provide cen-tral collisions of the opposing bunches. Since ground motion (GM) amplitudes are likely to be larger than the required tolerances, an Active Vibration Control (AVC) system is required to damp quadrupole motion to the desired value of 0.2 nm RMS at 4 Hz. This paper focuses on the vertical final focus quadrupoles (QD0, QF1) stabilization and demonstrates its feasibility. An AVC system to be installed under QD0 and QF1 has been developed and successfully tested at LAPP. Based on a dedicated homemade sensor with an ex-tremely low internal noise level of 0.05 nm at 4 Hz, it damps GM in the frequency range [3;70] Hz by up to 30 dB, leading to RMS values of approximately 0.25 nm at 4 Hz. Simulations based on GM measured in the Compact Muon Solenoid (CMS) experimental hall [2] show that with such a GM level, the specifications would only be achieved with a Passive Insulation (PI) system, which would filter ground motion starting at ~ 25 Hz  
DOI • reference for this paper ※ https://doi.org/10.18429/JACoW-IPAC2017-TUPAB001  
Export • reference for this paper using ※ BibTeX, ※ LaTeX, ※ Text/Word, ※ RIS, ※ EndNote (xml)