IPAC2011 - List of Authors (Yang, C.-S.)

Paper	Title	Page
THPC146	The Radiated EMI Isolation for TPS Kicker Magnet*	3227
	C.S. Chen, C.K. Chan, C.L. Chen, Y.L. Chu, K.H. Hsu, C.Y. Kuo, Y.-H. Liu, C.-S. Yang NSRRC, Hsinchu, Taiwan
	Electromagnetic interference is a critical problem for electronic equipment, especially for those sophisticated measuring sensors using in TLS. Therefore, lots of efforts have been made to isolate the EM noise from the kicker magnets. In this article, different thicknesses of aluminum chambers are applied to block the radiated EM noise. Furthermore, the different widths of slits simulate the necessary openings on kicker assembly. According to the results of small-scale experiment, some parameters are obtained to design the enclosure of kicker magnet. Compared the results with the data from the original scale kicker, these parameters provide a believable guideline in the beginning of design status.

THPC147	TPS SR Kicker Prototype Installation Status*	3230
	Y.-H. Liu, C.K. Chan, C.-S. Chen, Y.L. Chu, K.H. Hsu, H.P. Hsueh, C.K. Kuan, C.Y. Kuo, C.-S. Yang NSRRC, Hsinchu, Taiwan
	The purpose of this paper is to illustrate the installation sequence of TPS SR kicker. Because of adding the rotation function in row direction, the position of every component of kicker must be very precise. The kicker magnet and EMI enclosure were fastened on the rotation motor plate which could rotate ±3.0 mrad. The ceramic chamber remain fixed on the bottom plate in order to let the bellow stress free during rotation. After installation, the inductance measurement and the high voltage breakdown test were also tested. The experimental results showed the good uniformity and reached the expected request. The field mapping and EMI prevention schemes will be tested in the future.

Paper

Title

Page

The Radiated EMI Isolation for TPS Kicker Magnet*

3227

C.S. Chen, C.K. Chan, C.L. Chen, Y.L. Chu, K.H. Hsu, C.Y. Kuo, Y.-H. Liu, C.-S. Yang
NSRRC, Hsinchu, Taiwan

Electromagnetic interference is a critical problem for electronic equipment, especially for those sophisticated measuring sensors using in TLS. Therefore, lots of efforts have been made to isolate the EM noise from the kicker magnets. In this article, different thicknesses of aluminum chambers are applied to block the radiated EM noise. Furthermore, the different widths of slits simulate the necessary openings on kicker assembly. According to the results of small-scale experiment, some parameters are obtained to design the enclosure of kicker magnet. Compared the results with the data from the original scale kicker, these parameters provide a believable guideline in the beginning of design status.

THPC147

TPS SR Kicker Prototype Installation Status*

3230

Y.-H. Liu, C.K. Chan, C.-S. Chen, Y.L. Chu, K.H. Hsu, H.P. Hsueh, C.K. Kuan, C.Y. Kuo, C.-S. Yang
NSRRC, Hsinchu, Taiwan

The purpose of this paper is to illustrate the installation sequence of TPS SR kicker. Because of adding the rotation function in row direction, the position of every component of kicker must be very precise. The kicker magnet and EMI enclosure were fastened on the rotation motor plate which could rotate ±3.0 mrad. The ceramic chamber remain fixed on the bottom plate in order to let the bellow stress free during rotation. After installation, the inductance measurement and the high voltage breakdown test were also tested. The experimental results showed the good uniformity and reached the expected request. The field mapping and EMI prevention schemes will be tested in the future.