Author: Pivi, M.T.F.
Paper Title Page
MOOCA03 Updates to the International Linear Collider Damping Rings Baseline Design 32
 
  • S. Guiducci, M.E. Biagini
    INFN/LNF, Frascati (Roma), Italy
  • G. Dugan, M.A. Palmer, D. L. Rubin
    CLASSE, Ithaca, New York, USA
  • J. Gao, D. Wang
    IHEP Beijing, Beijing, People's Republic of China
  • M.T.F. Pivi, Y. Sun
    SLAC, Menlo Park, California, USA
  • J. Urakawa
    KEK, Ibaraki, Japan
 
  A new baseline design for the International Linear Collider (ILC) damping rings has been adopted which reduces the ring circumference to 3.2 km from 6.4 km. This design change is associated with a revised plan to operate the ILC with one half the beam current originally specified in the ILC Reference Design Report. We describe the new layout and lattice that has been developed for the shorter ring. In addition, we discuss features of the new design that will allow operation at a 10Hz repetition rate which is twice the rate specified for baseline operation. Finally, we examine the implications for restoring operation with the originally specified beam current while maintaining the smaller ring circumference.  
slides icon Slides MOOCA03 [2.381 MB]  
 
MOPS088 Simulation of Electron Cloud Beam Dynamics for CesrTA 808
 
  • K.G. Sonnad, G. Dugan, M.A. Palmer, G. Ramirez, H.A. Williams
    CLASSE, Ithaca, New York, USA
  • K.R. Butler
    Cornell University, Ithaca, New York, USA
  • M.T.F. Pivi
    SLAC, Menlo Park, California, USA
 
  This presentation provides a comprehensive set of results obtained using the simulation program CMAD. CMAD is being used for studying electron cloud induced beam dynamics issues for CesrTA, which is a test facility for studying physics associated with electron and positron damping rings. In particular, we take a closer look at electron cloud induced effects on positron beams, including head-tail motion, emittance growth and incoherent tune shifts for parameters specific to ongoing experimental studies at CesrTA. The correspondence between simulation and experimental results will also be discussed.
Work supported by US Department of Energy grant number DE-FC02-08ER41538
and the National Science Foundation grant number PHY-0734867
 
 
TUPC030 Recommendation for Mitigations of the Electron Cloud Instability in the ILC 1063
 
  • M.T.F. Pivi, L. Wang
    SLAC, Menlo Park, California, USA
  • L.E. Boon, K.C. Harkay
    ANL, Argonne, USA
  • J.A. Crittenden, G. Dugan, M.A. Palmer
    CLASSE, Ithaca, New York, USA
  • T. Demma, S. Guiducci
    INFN/LNF, Frascati (Roma), Italy
  • M.A. Furman
    LBNL, Berkeley, California, USA
  • K. Ohmi, K. Shibata, Y. Suetsugu, J. Urakawa
    KEK, Ibaraki, Japan
  • C. Yin Vallgren
    Chalmers University of Technology, Chalmers Tekniska Högskola, Gothenburg, Sweden
 
  Funding: Work supported by the Director, Office of Science, High Energy Physics, U.S. DOE under Contract No. DE-AC02-76SF00515.
Electron cloud has been identified as one of the highest priority issues for the ILC Damping Rings (DR). A working group has evaluated the electron cloud effect and instability, and mitigation solutions for the electron cloud formation. Working group deliverables include recommendations for the baseline and alternate solutions for the electron cloud mitigation in various regions of the ILC Positron DR, which is presently assumed to be the 3.2km design. Detailed studies of a range of mitigation options including coatings, clearing electrodes, grooves and novel concepts, were carried out over the previous several years by nearly 50 researchers, and the results of the studies form the basis for the recommendation. The assessments of the benefits or risks associated with the various options were based on a systematic ranking scheme. The recommendations are the result of the working group discussions held at numerous meetings and during a dedicated workshop. The mitigation choices will be also presented in a more detailed report later in 2012. In addition, a number of items requiring further investigation were identified and studies will be carried out at CesrTA and other institutions.
 
 
WEPC105 Multiparticle Simulation of Intrabeam Scattering for SuperB 2259
 
  • T. Demma, M.E. Biagini, M. Boscolo
    INFN/LNF, Frascati (Roma), Italy
  • K.L.F. Bane, A. Chao, M.T.F. Pivi
    SLAC, Menlo Park, California, USA
 
  Intrabeam scattering (IBS) is associated with multiple small angle scattering events leading to emittance growth. In most electron storage rings, the growth rates arising from IBS are much longer than damping times due to synchrotron radiation, and the effect on emittance growth is negligible. However, IBS growth rates increase with increasing bunch charge density, and for storage rings such as SuperB, that operate with high bunch charges and very low vertical emittance, the IBS growth rates can be large enough to produce significant emittance increase. Several formalisms have been developed for calculating IBS growth rates in storage rings*. However these models, based on Gaussian bunch distributions, cannot investigate some interesting aspects of IBS such as its evolution during the damping process and its effect on the beam distribution. We developed a multiparticle tracking code, based on the Binary Collision Model**, to investigate these effects. In this communication we present the structure of the code and simulation results obtained with particular reference to the SuperB parameters. Simulation results are compared with those of conventional IBS theories.
* A. Piwinski, Lect. Notes Phys. 296 (1988); J.D. Bjorken and S.K. Mtingwa, Part. Accel. 13 (1983); K. Kubo et al., Phys. Rev. ST-AB 8 (2005).
** Peicheng Yu et al., Phys. Rev. ST–AB 12 (2009).
 
 
WEPZ017 ESTB: A New Beam Test Facility at SLAC 2808
 
  • M.T.F. Pivi, H. Fieguth, C. Hast, R.H. Iverson, J. Jaros, R.K. Jobe, L. Keller, T.V.M. Maruyama, D.R. Walz, M. Woods
    SLAC, Menlo Park, California, USA
 
  Funding: Work supported by the Director, Office of Science, High Energy Physics, U.S. DOE under Contract No. DE-AC02-76SF00515.
End Station A Test Beam (ESTB) is a beam line at SLAC using a small fraction of the bunches of the 13.6 GeV electron beam from the Linac Coherent Light Source (LCLS), restoring test beam capabilities in the large End Station A (ESA) experimental hall. ESTB will provide one of a kind test beam essential for developing accelerator instrumentation and accelerator R&D, performing particle and particle astrophysics detector research, linear collider machine and detector interface (MDI) R&D studies, development of radiation-hard detectors, and material damage studies with several distinctive features. In the past, 18 institutions participated in the ESA program at SLAC. In stage I, 4 new kicker magnets will be added to divert 5 Hz of the LCLS beam to ESA. A new beam dump is installed and a new Personnel Protection System (PPS) is built in ESA. In stage II, we plan to install a secondary hadron target, able to produce pions up to about 12 GeV/c at 1 particle/pulse. We report about the ESTB commissioning, status and plan for tests.
 
 
MOPS083 Update on Electron Cloud Mitigation Studies at Cesr-TA* 796
 
  • J.R. Calvey, M.G. Billing, J.V. Conway, G. Dugan, S. Greenwald, Y. Li, X. Liu, J.A. Livezey, J. Makita, R.E. Meller, M.A. Palmer, S. Santos, R.M. Schwartz, J.P. Sikora, C.R. Strohman
    CLASSE, Ithaca, New York, USA
  • S. Calatroni, G. Rumolo
    CERN, Geneva, Switzerland
  • K. Kanazawa, Y. Suetsugu
    KEK, Ibaraki, Japan
  • M.T.F. Pivi, L. Wang
    SLAC, Menlo Park, California, USA
 
  Funding: Work supported by the US National Science Foundation (PHY-0734867) and Department of Energy (DE-FC02-08ER41538)
Over the course of the past three years, the Cornell Electron Storage Ring (CESR) has been reconfigured to serve as a test facility for next generation particle accelerators. A significant part of this program has been the installation of several diagnostic devices to measure and quantify the electron cloud effect, a potential limiting factor in these machines. In particular, more than 30 Retarding Field Analyzers (RFAs) have been installed in CESR. These devices measure the local electron cloud density and energy distribution, and can be used to evaluate the efficacy of different cloud mitigation techniques. This paper will provide an overview of RFA results obtained at CesrTA over the past year, including measurements taken as function of bunch spacing and wiggler magnetic field. Understanding these results provides a great deal of insight into the behavior of the electron cloud.
 
 
THPZ003 The SuperB Project: Accelerator Status and R&D 3684
 
  • M.E. Biagini, S. Bini, R. Boni, M. Boscolo, B. Buonomo, T. Demma, E. Di Pasquale, A. Drago, L.G. Foggetta, S. Guiducci, S.M. Liuzzo, G. Mazzitelli, L. Pellegrino, M.A. Preger, P. Raimondi, U. Rotundo, C. Sanelli, M. Serio, A. Stecchi, A. Stella, S. Tomassini, M. Zobov
    INFN/LNF, Frascati (Roma), Italy
  • M.A. Baylac, O. Bourrion, J.-M. De Conto, N. Monseu, C. Vescovi
    LPSC, Grenoble, France
  • K.J. Bertsche, A. Brachmann, Y. Cai, A. Chao, M.H. Donald, R.C. Field, A.S. Fisher, D. Kharakh, A. Krasnykh, K.C. Moffeit, Y. Nosochkov, A. Novokhatski, M.T.F. Pivi, J.T. Seeman, M.K. Sullivan, S.P. Weathersby, A.W. Weidemann, U. Wienands, W. Wittmer, G. Yocky
    SLAC, Menlo Park, California, USA
  • S. Bettoni
    PSI, Villigen, Switzerland
  • A.V. Bogomyagkov, I. Koop, E.B. Levichev, S.A. Nikitin, I.N. Okunev, P.A. Piminov, D.N. Shatilov, S.V. Sinyatkin, P. Vobly
    BINP SB RAS, Novosibirsk, Russia
  • B. Bolzon, M. Esposito
    CERN, Geneva, Switzerland
  • F. Bosi
    INFN-Pisa, Pisa, Italy
  • L. Brunetti, A. Jeremie
    IN2P3-LAPP, Annecy-le-Vieux, France
  • A. Chancé
    CEA, Gif-sur-Yvette, France
  • P. Fabbricatore, S. Farinon, R. Musenich
    INFN Genova, Genova, Italy
  • E. Paoloni
    University of Pisa and INFN, Pisa, Italy
  • C. Rimbault, A. Variola
    LAL, Orsay, France
  • Y. Zhang
    IHEP Beijing, Beijing, People's Republic of China
 
  The SuperB collider project has been recently approved by the Italian Government as part of the National Research Plan. SuperB is a high luminosity (1036 cm-2 s-1) asymmetric e+e collider at the Y(4S) energy. The design is based on a “large Piwinski angle and Crab Waist” scheme already successfully tested at the DAΦNE Phi-Factory in Frascati, Italy. The project combines the challenges of high luminosity colliders and state-of-the-art synchrotron light sources, with two beams (e+ at 6.7 and e- at 4.2 GeV) with extremely low emittances and small beam sizes at the Interaction Point. As unique features, the electron beam will be longitudinally polarized at the IP and the rings will be able to ramp down to collide at the tau/charm energy threshold with one tenth the luminosity. The relatively low beam currents (about 2 A) will allow for low running (power) costs compared to similar machines. The insertion of beam lines for synchrotron radiation users is the latest feature included in the design. The lattice has been recently modified to accommodate insertion devices for X-rays production. A status of the project and a description of R&D in progress will be presented.