Author: Kuo, C.Y.
Paper Title Page
WEPO020 Magnetic Field Inspection and Analysis of Multipole Lattice Magnets using a Rotating-coil Measurement System* 2442
  • J.C. Jan, C.-H. Chang, Y.L. Chu, T.Y. Chung, C.-S. Hwang, C.Y. Kuo, F.-Y. Lin
    NSRRC, Hsinchu, Taiwan
  A precise rotating-coil measurement system (RCS) was constructed to characterize the field quality and field center of multipole lattice magnets of Taiwan Photon Source (TPS). The mechanical center of magnets is determined by the two references of the magnet-feet and the RCS system is used to characterize the field center. The location of the magnetic field center is quantitatively accurate to better than 20 micro-meter in the horizontal direction; the granite support height of the RCS system is accurate within 5 micro-meter after artificial polishing. The measurement reproducibility of the field center was better than 10 micro-meter when the magnets were reinstalled. The relative accuracy of the multipoles components is better than 2×10-5. This paper reports the details of the bench construction and the unit composition. The field center with RCS measurement will be compared and discussed with the 3D-coordinate-measuring machine. The multipole errors obtained from RCS will be compared with a Hall-probe measurement system.  
THPC146 The Radiated EMI Isolation for TPS Kicker Magnet* 3227
  • C.S. Chen, C.K. Chan, C.L. Chen, Y.L. Chu, K.H. Hsu, C.Y. Kuo, Y.-H. Liu, C.-S. Yang
    NSRRC, Hsinchu, Taiwan
  Electromagnetic interference is a critical problem for electronic equipment, especially for those sophisticated measuring sensors using in TLS. Therefore, lots of efforts have been made to isolate the EM noise from the kicker magnets. In this article, different thicknesses of aluminum chambers are applied to block the radiated EM noise. Furthermore, the different widths of slits simulate the necessary openings on kicker assembly. According to the results of small-scale experiment, some parameters are obtained to design the enclosure of kicker magnet. Compared the results with the data from the original scale kicker, these parameters provide a believable guideline in the beginning of design status.  
THPC147 TPS SR Kicker Prototype Installation Status* 3230
  • Y.-H. Liu, C.K. Chan, C.-S. Chen, Y.L. Chu, K.H. Hsu, H.P. Hsueh, C.K. Kuan, C.Y. Kuo, C.-S. Yang
    NSRRC, Hsinchu, Taiwan
  The purpose of this paper is to illustrate the installation sequence of TPS SR kicker. Because of adding the rotation function in row direction, the position of every component of kicker must be very precise. The kicker magnet and EMI enclosure were fastened on the rotation motor plate which could rotate ±3.0 mrad. The ceramic chamber remain fixed on the bottom plate in order to let the bellow stress free during rotation. After installation, the inductance measurement and the high voltage breakdown test were also tested. The experimental results showed the good uniformity and reached the expected request. The field mapping and EMI prevention schemes will be tested in the future.