A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

van Schalkwyk, P. A.

Paper Title Page
TUPC022 Non-destructive Beam Position and Profile Measurements Using Light Emitted by Residual Gas in a Cyclotron Beam Line 1095
 
  • J. Dietrich
    FZJ, Jülich
  • C. Boehme
    UniDo/IBS, Dortmund
  • A. H. Botha, J. L. Conradie, M. A. Crombie, J. H. Du Toit, D. T. Fourie, H. W. Mostert, P. F. Rohwer, P. A. van Schalkwyk
    iThemba LABS, Somerset West
  • T. Weis
    DELTA, Dortmund
 
  Non-destructive beam position and profile measurements were made in the transfer beam line between an 8 MeV solid-pole injector cyclotron and a 200 MeV separated-sector cyclotron that is used for nuclear physics research, radioisotope production and proton and neutron therapy. Light emitted from the beam induced ionization of residual gas particles was measured using a multi-cathode photomultiplier tube (PMT). The PMT was mounted outside the vacuum system on a diagnostic chamber and light passing through a glas window was focused on the photocathode array by means of a lens. The anode currents of the PMT were measured with computer-controlled electronic equipment recently developed for measuring the currents of multi-wire beam profile monitors. Software was developed to control the measurement processes, remove offset values and further process the data digitally. The measured beam positions and profiles were compared with those determined with a multi-wire beam profile monitor for a 3.14 MeV proton beam. It was necessary to shield the PMT from gamma rays generated on nearby slits. The design of the measuring equipment is discussed and the results of the measurements are presented.