A   B   C   D   E   F   G   H   I   J   K   L   M   N   O   P   Q   R   S   T   U   V   W   X   Y   Z  

Kolka, A. A.

Paper Title Page
THPP002 EMMA RF Cavity Design and Prototype Testing at Daresbury 3374
 
  • C. D. Beard, P. A. Corlett, D. M. Dykes, P. Goudket, C. Hill, P. A. McIntosh, A. J. Moss, J. F. Orrett, J. H.P. Rogers, A. E. Wheelhouse, E. Wooldridge
    STFC/DL/ASTeC, Daresbury, Warrington, Cheshire
  • N. Bliss
    STFC/DL, Daresbury, Warrington, Cheshire
  • A. E. Bogle, T. L. Grimm, A. A. Kolka
    Niowave, Inc., Lansing, Michigan
  
  At PAC’07 we discussed the design of a prototype cavity to be used on EMMA*. EMMA is a prototype non-scalling FFAG. It will contain 19 RF cavities operating at 1.3 GHz with a baseline accelerating voltage of 120 kV. A prototype cavity has been manufactured by Niowave, Inc. and we will present a discussion of its RF and mechanical design. This cavity was put through low power tests, to determine frequency, tuning range, shunt impedance and Q of the cavity; and high power tests, to confirm power handling ability, when it arrived at Daresbury Laboratory this spring. The results of these tests were compared to the simulations and a bead pull was carried out to obtain the field profile. The cavities for EMMA are likely to be powered by IOTs, these will be used for the high power tests, which will demonstrate cavity operation to the required maximum of 180 kV.

*E. Wooldridge et al. "RF Cavity Development for FFAG Application on ERLP at Daresbury," Proceedings of PAC’07, Albuquerque, NM (2007).