| Paper |
Title |
Page |
| MOPP144 |
The First Cool-down Tests of the 6 Meter-Long-Cryomodules for Superconducting RF Test Facility (STF) at KEK
|
892 |
| |
- N. Ohuchi, F. Furuta, K. Hara, H. Hayano, N. Higashi, Y. Higashi, H. Hisamatsu, K. Hosoyama, E. Kako, Y. Kojima, M. Masuzawa, H. Matsumoto, H. Nakai, S. Noguchi, T. Saeki, K. Saito, T. Shishido, A. Terashima, N. Toge, K. Tsuchiya, K. Yokoya
KEK, Ibaraki
- M. H. Tsai
NSRRC, Hsinchu
- Q. J. Xu
IHEP Beijing, Beijing
|
|
| |
KEK is presently constructing the Superconducting RF Test Facility (STF) as the center of the ILC-R&D in Asia from 2005. In this project, KEK aims to get the manufacturing and operational experiences of the RF cavity and cryomodule toward the ILC, and two cryomodules have been developed. These cryomodules are 6 meter long and have 4 nine-cell cavities in each cryostat. The basic cross section designs of the cryomodules are almost same as the design of TESLA type-III, however, each cryostat has the different type of cavities, TESLA type and Low-Loss type. The tests for the cryomodules are planed to be performed at three steps. In the first test, measurements of the cryogenic performances of these cryomodules are the main objective. One nine-cell cavity was assembled in each cryostat and the cool-down of the two cryomodules was performed. In the following tests, the four nine-cell cavities will be assembled in each cryostat as the complete integration and the beam test will be performed. In this paper, we will report the design of the cryomodules and the cryogenic performances at the first cold test.
|
|
| TUPP071 |
Development of TiN Coating System for Beam Ducts of KEK B-factory
|
1700 |
| |
- K. Shibata, H. Hisamatsu, K.-I. Kanazawa, M. Shirai, Y. Suetsugu
KEK, Ibaraki
|
|
| |
A titanium nitride (TiN) coating system for the copper beam ducts of KEK B-factory (KEKB) was developed to reduce the secondary electron yield (SEY) from the inner surface, which would mitigate the electron cloud instability. The coating was done by DC magnetron sputtering of titanium in argon and nitrogen atmospheres. The duct was set vertically, and a titanium cathode rod was hung from the top on the center axis of the duct. A magnetic field was supplied by a movable solenoid coil placed outside of the duct. Preliminary experiments using small copper samples showed that a 200-nanometer-thick TiN film coated at 150 degree is the best from the viewpoints of SEY and adhesion strength. The SEY of the coated sample decreased to 60% of that of non-coated copper after an electron dose of 0.01 C/mm2, and the maximum SEY was 0.84. Using this system, five ducts with a length of up to 3.6 m were successfully coated. Some of them were installed into the KEKB positron ring last summer, and no problem was found in the following beam operation with a beam current of up to 1.6 A. One coated duct with an electron monitor was installed this winter, and the effect of the coating will be checked.
|
|