| Paper | Title | Page |
|---|---|---|
| MOPD012 | Half Wave Injector Design for WiFEL | 469 |
|
||
|
Seeded FELs will require exceptional beam quality. The Wisconsin FEL (WiFEL) requires peak currents of greater than 1 kA with less than 1 mm-mrad transverse slice emittance and 1·10-4 δp/p at the undulator. To perform the obligatory bunch compression after the injector without allowing micro-bunching will require very smooth bunch energy and density profiles and relatively low compression ratios. An injector which uses a low frequency, superconducting, half wave resonator gun combined with self-inflating, ellipsoidal bunches* to meet those requirements is described. The superconducting radio frequency TEM-class cavities have been in use for more than 25 years and because of their potential for flat field profiles, are desirable as electron gun structures. A Superfish model and field map of the specific gun cavity is presented. ASTRA** simulations from the cathode to 120MeV are provided. A description is given of the technique used to emittance compensate the space charge induced energy chirp while maintaining the peak bunch current.
* O. J.Luiten, et al., Phys. Rev. Lett. Vol 93, 094802 (2004) |
||
| THPP002 | EMMA RF Cavity Design and Prototype Testing at Daresbury | 3374 |
|
||
|
At PAC’07 we discussed the design of a prototype cavity to be used on EMMA*. EMMA is a prototype non-scalling FFAG. It will contain 19 RF cavities operating at 1.3 GHz with a baseline accelerating voltage of 120 kV. A prototype cavity has been manufactured by Niowave, Inc. and we will present a discussion of its RF and mechanical design. This cavity was put through low power tests, to determine frequency, tuning range, shunt impedance and Q of the cavity; and high power tests, to confirm power handling ability, when it arrived at Daresbury Laboratory this spring. The results of these tests were compared to the simulations and a bead pull was carried out to obtain the field profile. The cavities for EMMA are likely to be powered by IOTs, these will be used for the high power tests, which will demonstrate cavity operation to the required maximum of 180 kV.
*E. Wooldridge et al. "RF Cavity Development for FFAG Application on ERLP at Daresbury," Proceedings of PAC’07, Albuquerque, NM (2007). |