Fukuma, H.

Paper	Title	Page
MOPP059	Study for ILC Damping Ring at KEKB	676
	K. Ohmi, J. W. Flanagan, H. Fukuma, K.-I. Kanazawa, H. Koiso, M. Masuzawa, Y. Ohnishi, K. Oide, Y. Suetsugu, M. Tobiyama KEK, Ibaraki M. T.F. Pivi SLAC, Menlo Park, California
	ILC damping ring consists of very low emittance electron and positron storage rings. It is necessary for ILC damping ring to study electron cloud effects in such low emittance positron ring. We propose a low emittance operation of KEKB to study the effects.
TUOCM02	X-ray Monitor Based on Coded-aperture Imaging for KEKB Upgrade and ILC Damping Ring	1029
	J. W. Flanagan, H. Fukuma, S. Hiramatsu, H. Ikeda, K.-I. Kanazawa, T. Mitsuhashi, J. Urakawa KEK, Ibaraki J. P. Alexander CLASSE, Ithaca M. A. Palmer Cornell University, Laboratory for Elementary-Particle Physics, Ithaca, New York G. S. Varner UH, Honolulu, HI
	We present here design considerations for an x-ray monitor for high-resolution (a few um) and fast response (sub-nanosecond) for beam profile measurements to be used at an upgraded KEKB and/or ILC damping ring. The optics for the monitor are based on a technique borrowed from x-ray astronomy, coded-aperture imaging, which should permit broad-spectrum, low-distortion measurements to maximize the observable photon flux per bunch. Coupled with a high-speed digitizer system, the goal is to make sub-bunch-length, turn-by-turn measurements of beam profile and position.
	Slides
TUPC040	Measurements of Beam-beam Kick using a Gated Beam-position Monitor under Crabbing Collision at KEKB	1143
	T. Ieiri, H. Fukuma, Y. Funakoshi, M. Masuzawa, K. Ohmi, M. Tobiyama KEK, Ibaraki
	KEKB is a double-ring electron/positron collider with a horizontal crossing-angle. The crab cavities installed in 2007 achieved an effective head-on collision and gained a higher specific luminosity. A gated beam-position monitor is a tool to measure the beam-beam effects. A beam-beam kick curve was measured by comparing the beam position between colliding and non-colliding bunches, while shifting the beam orbit at the interaction point (IP). An effective horizontal beam size at the IP was obtained from a linear part of the beam-beam kick around the central orbit. The estimated beam size agreed with a calculated value including the dynamic effects. It was confirmed that the effective horizontal beam size was reduced by the crabbing collision, as expected from a calculation with a rigid Gaussian model. When a horizontal orbit offset was larger than a beam size, however, we found that the measured beam-beam kick curve deviated from calculated values using the Gaussian model. The result suggests that the beam profile might enlarge horizontally in the peripheral part.